8AXIS 241Q/241S - Product description
Switches & connectors
DIP switch (AXIS 241Q) - A corresponding line termination switch is supplied for each video input. All units are shipped with line termination enabled for each video input, that is, with the DIP switch set in the down position.
DIP switch (AXIS 241S) - Upon delivery the dip switch on the AXIS 241S is configured for composite video input, as follows:
Switch | 1 | 2 | 3 | 4 |
|
|
|
|
|
Description | 75 ohm video in | 75 ohm video out | Connects video in and | Not used |
termination | termination | video out |
| |
|
| |||
|
|
|
|
|
Composite video input | on | off | on | n/a |
|
|
|
|
|
Y/C video input | on | on | off | n/a |
|
|
|
|
|
Note: If the video source is to be connected in parallel with other equipment, disable the input termination by turning the corresponding DIP switch to the up position (OFF). Failure to do so may cause reduced image quality.
Control Button - Press this button to restore the factory default settings, as described in Resetting to the factory default settings, on page 48, or to install the video server using AXIS Internet Dynamic DNS Service (See the Axis Video Server Installation Guide).
Video Input - The video input is connected using a coax/BNC connector. Physical connections made using 75 ohm coaxial video cable have a recommended maximum length of 800 feet (250 meters).
Video Output (AXIS 241S only) - Loopthrough connection to the video signal from the Video In connector. Terminated with a coaxial/BNC connector. Allows direct connection of an external monitor for example. Set DIP switch to ON when in use.
Rear panel
Network | ||
connector | connector | |
| connector | |
|
|
Power adapter connector
Serial number on underside label
Power adapter connector - Connect the power adapter.