Axis Communications user manual Mounting, Install the Axis 206/206M

AXIS 206 - Mounting 10

Mounting

1.	If required, use the 3 supplied screws to fix the base plate to	Wall mounting
	a flat surface.
2.	To use the shorter stand, e.g. for wall mounting, unscrew
	the lock ring to release the camera, and remove the
	extension section.
3.	Re-attach the camera, adjust the angle and gently tighten
	the lock ring.

Important! Lock ring

The AXIS 206 (all models) is designed for indoor use only, and must always be positioned where it is not exposed to direct sunlight or strong halogen light, which can cause permanent damage to the camera’s image sensor. Damage as a result of exposure to strong light is not covered by the Axis warranty.

Install the AXIS 206/206M

Follow the steps below to install the AXIS 206/206M on your local network (LAN). To install the AXIS 206W, please see page 15.

1.Using the self-adhesive strip, attach the supplied cable clip to the rear panel.

2.Position and mount the camera as required - see above.

3.Connect the power adapter to the camera.

4.Fasten the power cable in the cable clip. This helps prevent accidental cable disconnection.

5.Connect the AXIS 206/206M to the network using a standard RJ-45 network cable.

6.Select a method for setting the IP address - see the following page.