appendix
PROBLEM |
| SOLUTION |
No JPEG file is transferred via | y Verify the settings in the following sequence: | |
| A. Check <Data & Time> settings. | |
video analysis event of camera |
| B. The <IV analysis Function> should be set to <Enable>. |
even when the <IV analysis |
| |
Function> is set to <Enable>. |
| C. Alarm Video Transmission must be enabled. |
Can <Set Rules> be configured | y Yes, it can be. You can set rules for events despite of the intelligent | |
even when the <IV analysis |
| video analysis setting. |
Function> is set to <Disable>? |
| |
No signal is found at the Alarm |
|
|
Output port even when an | y | Check alarm output port settings. |
intelligent video analysis event is |
| |
generated. |
|
|
Cannot record into the SD memory | y Check if the memory card is defective. | |
card. | y Check if the write protection tab of the memory card is set to "Lock". | |
SD memory indicator does not | y Check if the memory card is defective. | |
turn on even when the SD memory | y Check if the <Record> is checked in <Setup> <Event> <SD | |
card is inserted. |
| Record> menu. |
SD memory card is inserted but | y Check if the memory card is inserted in the proper direction. Operation | |
| of memory card that is formatted by other devices is not guaranteed with | |
the camera does not operate |
| this camera unit |
properly. | y Format the memory card again in <Setup> <Event> <SD | |
|
| Record> menu. |
Cannot format the SD memory | y Check if the write protection tab of the memory card is set to "Lock". | |
card. |
|
|