Cisco Systems 2500 Series Described in the Resetting the IP Camera section on, Rear of IP Camera

Chapter 1 Overview

IP Camera Physical Details

Figure 1-2and the table that follows describe the items on the rear of the IP camera.

Figure 1-2 Rear of IP Camera

			1	Antenna connectors	Antennas screw into these connectors and are used for
				(wireless model only)	communication in wireless networks.
2				Reset button	Recessed button that reboots the IP camera or resets it to a default
					state. You can use a pin or paper clip to depress it. It can be used
					any time that the IP camera is on and can have various effects, as
					described in the “Resetting the IP Camera” section on page 2-9.
3				Network LED (amber)	Indicates information about the network connections as follows:
					• On—LAN or wireless connection is detected
					• Off—LAN or wireless connection is not detected
					• Blinking—Data is being transmitted or received via the LAN
					or wireless connection
4				LAN port	Accepts a standard LAN cable to connect the IP camera to a
					10/100BASETrouter, or switch.
					On the wireless IP camera model, attaching a LAN cable disables
					the wireless interface. Only one interface, wired or wireless, can be
					active at a time.
					Connect or disconnect the LAN cable only when the IP camera is
					powered off. Doing so while the IP camera is powered on does not
					switch the interface between wired and wireless.
5				PoE LED (green)	Indicates information about PoE as follows:
					• On—PoE connection is detected
					• Off—PoE connection is not detected
		Cisco Video Surveillance 2500 Series IP Camera User Guide
	1-4				OL-19273-02