How to use OSD Menu
FAN/HEATER SETUP |
|
FAN RUN TEMP | 40°C |
HEATER RUN TEMP | 5°C |
BACK
EXIT
•FAN RUN TEMP
Above this temperature, the blower fan will start automatically.
Range: 30°C ~ 80°C (86°F ~ 176°F)
•HEATER RUN TEMP
Bellow this temperature, the Heater will be tuned on automatically.
Range:
FAN and HEATER are only available in C7325 model.
SET HOME POSITION
If you change the location of Home position, all horizontal locations of functions such as preset, pattern, scan, auto pan, and privacy zone mask will be shifted based on changed Home position.
* Set Home Position?
When you replace the camera block or the orientation of camera is changed due to maintenance operations, it is very diffi cult to maintain same pan orientation. Therefore, all function data depending on pan orientation such as preset, pattern, scan, auto pan, and privacy zone mask are not useful any more accordingly. However, even in this case, you can reuse the data if you redefi ne Set Home Position on the previous Home position. It is recommendable to memorize the target scene of current Home position.
SET NORTH DIRECTION
ENG |
MOVE TO TARGET POSITION [NEAR:SELECT/ FAR:CANCEL]
0/0/x1/N
MOVE TO TARGET POSITION [NEAR:SELECT/ FAR:CANCEL]
0/0/x1/N
•SET HOME POSITION
Home Position means the origin of PAN angle calculation. The value of PAN angle displayed on the screen is based on this Home Position.
By using Joystick, move the camera to the desired position and press ENTER (NEAR/SAVE).
It is noted that Home is not effective to Tilt angle.
•SET NORTH DIRECTION
You can set up North direction.
By using Joystick, move the camera to the desired NORTH position and press ENTER (NEAR/SAVE).
The direction will be displayed in the screen [PAN AXIS / TILT AXIS / ZOOM / DD]
DD is direction and will be displayed from: N/NE/E/SE/S/SW/W/NW
English – 35