System Info | Samsung SCC-C6407(P) guide

TURBO P/T

This function doubles up the speed of PAN/TILT movement by manual operation of PAN/TILT. The speed may go up to 180°/sec(PAN).

AUTO CAL

This function turns on or off Auto Calibration. SCC-C6407(P) has the Auto Calibration function to improve the precision of LENS and PAN/TILT motor. You may set to OFF/6H/12H/18H/24H. Without user’s key input for the time designated by the user, A.C. will appear on the screen while initializing LENS and PAN/TILT.

	(OTHER SET)
	(OTHER SET)
	PROPORTIONAL P/T		ON
	TURBO P/T		OFF
	AUTO CAL.		OFF
	D-FLIP		ON
	CAM RESET		...
	LANGUAGE		ENGLISH
	PASSWORD		ON...
	EXIT		QUIT

➜

Press [Enter]

(PASSWORD)

0	1	2	3	4
5	6	7	8	9

✽ ✽ ✽ ✽

RET

D-FLIP

When D-FLIP is off, TILT movement ranges from 0° to 90°. When D-FLIP is on, TILT movement ranges from 0° to 180°.

When D-FLIP is on, images mirror vertically and horizontally in the area beyond TILT 90°.

CAM RESET

CAM RESET clears all the settings made so far and restores the factory default settings.

"CAMERA RESET?" message appears when you select CAM RESET. Select "CANCEL" to return to the menu setup display or select OK to restore the factory default settings.

Press UP/DOWN/LEFT/RIGHT key to locate the cursor on a number and press [ENTER] for password setup. After you finish inputting the 4 digits password and the 2nd row of the 4 digits PASSWORD input screen, input the selected password again for reassurance.

If correct, the cursor will move to RET.

Press [ENTER] at RET, and the selected password will be saved, returning to the OTHER SET screen.

Default password is 0123.

8. SYSTEM INFO

This menu allows you to check S/W version, communication protocol, baud rate, and address of SCC-C6407(P).

❈Be careful when performing a CAM RESET operation, as it deletes all setup values.

LANGUAGE

This function selects a language for MENU setup. Press UP/DOWN key to choose English, French, German, Spanish, or Italian, and the selected language will be applied to the full screen.

PASSWORD

This function selects or cancels the MENU setup password. Press [ENTER] at the state of PASSWORD ON, and the following screen will appear for password setup.

* * MAIN MENU * *

CAMERA SET...

VIDEO SET...

PRESET...

ZONE SET...

AUTO SET...

ALARM SET...

OTHER SET...

SYSTEM INFO...

➜

Press [Enter]

(SYSTEM INFO) FPGA VER. V1.000 ALARM VER. V1.000 MOTOR VER. V1.000 CAMERA VER. V1.000 EEPROM VER. V1.000

PROTOCOL SAMSUNG

COMM. TYPE	RS-485, HALF
BAUD RATE	38400
ADDRESS	0
SERIAL	000000000000000

RET

3-31

3-32