Samsung SCC-C6407(P) instruction manual Color/Bw, Sync, Auto, Level

(CAMERA SET)
CAMERA ID	ON...	➜
V-SYNC	INT
COLOR/BW	AUTO...	Press
MOTION DET	OFF
ZOOM SPEED	3	[Enter]
DIGITAL ZOOM	OFF
EXIT	QUIT

* " ... " Means there are Sub Menus.

(CAMERA ID)

AB C D E F G H I J K L M N O PQ R S T U V W X Y Z 0 1 2 3 4 5 6 7 8 9

:! - + ✽ ( ) /

SP ï î SP LOCATION...

RET

SCC-C6407P........

COLOR/BW

In the COLOR/BW menu, you can switch ON or OFF the IR (infrared) Filter.

In a poor illumination environment, the IR filter is turned off in the BW mode the its sensitivity increases as high as a black and white camera. On the other hand, the IR filter is turned on and the sensitivity decreases in the COLOR mode.

COLOR : The IR Filter is ON and the screen is normal. You can press the [Enter] key to set the COLOR GAIN LEVEL. And when the AGC function is on, you can set the AGC COLOER LEVEL.

(CAMERA SET)

(COLOR)

V-SYNC

In the V-SYNC menu, vertical synchronization can be selected. The vertical synchronization signal supported by the SCC-C6407(P) is the INT mode made by clock inside the SCC-C6407(P) and LINE mode adjusting vertical synchronization to the exterior power frequency.

Select LINE and press [Enter]. You will see the LINE LOCK submenu where you can adjust the phase of the LINE LOCK.

CAMERA ID	OFF
V-SYNC	INT
COLOR/BW	COLOR …
MOTION	OFF
ZOOM SPEED	0
DIGITAL ZOOM	0
EXIT	QUIT

➜

Press [Enter]

GAIN	(0)I--------
AGC COLOR	(0)----I----
RET

E

You can use the PHASE menu of the LINE LOCK submenu to assign as much PHASE as you want.

BW	: The IR Filter is OFF and the screen is black and white.
	(Sensitivity to low light is increased to a level comparable to a black
	and white camera.)
	Select BW and press [ENTER] and the additional menu to select

(CAMERA SET)
CAMERA ID	OFF
V-SYNC	LINE...
COLOR/BW	AUTO...
MOTION DET	OFF
ZOOM SPEED	3
DIGITAL ZOOM	OFF
EXIT	QUIT

➜

Press [Enter]

(LL-PHASE)

PHASE (-106)I--------

RET

	BURST ON/OFF will appear.
AUTO	: Select to automatically switch between the COLOR mode and BW
	mode depending on the amount of light. In low light conditions, the
	IR Filter is turned OFF and the sensitivity to low light is increased
	by switching to the BW mode, but in bright light conditions, the IR
	Filter is turned ON and the sensitivity is decreased by switching to
	the COLOR mode.
	Select AUTO and press [ENTER] and the additional menu to select
	BW LEVEL and DURATION will appear.
- BURST ON	: The color burst signal is output together with black and white
	composite video signal.
- BURST OFF : The color burst signal is not output.
- LEVEL	: You can set the brightness level that changes from COLOR mode
	to BW mode in 3 steps : LOW, MEDIUM, and HIGH.

-DURATION : Set the HOLDING time for switching between COLOR and BW mode depending the changes in the amount of light. You can set the HOLDING time to 10sec (S), 30sec, 60sec, or 300sec( L).

3-5 3-6