Samsung SCC-C6455N user manual Preparing Installation

Page 10

installation & connection

Preparing Installation

Use the ceiling installation template when you install the camera on the ceiling on your own.

Run the cables through the “” shaped hole on the center of the template, and remove films on the adhesives, and then attach the template on the desired location on the ceiling.

When installing the frames set, align all template’s screw holes and those of the frames set.

This template prevents dust entering from the ceiling into the camera assembly.

		<TEMPLATE>
CEILING	CABLES	CEILING TEMPLATE CABLES

Installation

1.Press the “SNAP FIT” on the “ADAPTOR” to open the “ADAPTOR”, and arrange cables so they pass out of the “FRAME SET”.

FRAME SET		FRAME SET
		FRAME SET
		ADAPTOR
	SNAP FIT	EXTERNAL
ADAPTOR	SNAP FIT	CABLES
		CABLES

		SNAP FIT

10_ installation & connection

00885A-NA_SCC-C6455N-ENG.indb 10

2009-08-05 오후 2:42:

Image 10

Contents Smart Dome Camera Overview English Overview FCC Statement Important safety instructions Contents Features What’s IncludedCamera At a GlanceFrame SET Preparing Installation InstallationScrew Fixing Hole Diagram Insert the cable into the Frame SET, and close the AdaptorProtective Tape from on the lens Button Frame SET Cover Camera Communication Protocol Setup Initial SetupCamera Address Setup Use SW606, SW605, and SW604 to specify the camera addressUse pins #5, #6 of SW603 to set the baud rate Baud Rate SetupSetting RS-422A/RS-485 Termination Factory default is 9600 BPSRS-422A/RS-485 Full Duplex Organization Same address in the networkConnecting to a monitor Connecting with Other deviceVideo terminal on the rear of monitor BNC Cable To connect Alarm OUT To connect AlarmTo connect the controller Power Supply Connecting the adaptor cableAdaptor Board Using OSD icons How to use the keyboard controllerCamera will resume the last run operation Main Menu Profile  ITSNight Camera ID You can configure the general settings of the camera moduleCamera SET VPSIris BLC With Backlight set toMotion With this, you can adjust the AGC level of aAGC DNRFlickerless ShutterSENS-UP XDRDAY/NIGHT You can specify a recording mode according to the sceneAny excessively bright area in a night scene will be MASKed  You can specify Mask 1 and 2 simultaneously Auto Switch or Auto FocusWhite BAL SET-AUTO SET are not availableDAY/NIGHT Display P/T Zoom SpeedDisplay Zoom Digital ZoomReverse SyncAGC Color SUP POSI/NEGAIntelligent Video You can enable the motion detection and tracking functionsWhen multiple motions continue arbitrarily AdvancedPrivacy Zone ResolutionAlarm OUT DisplayPreset Select Position and adjust PAN Select the preset numberSET. pages 24 ~ Auto SET Auto Pan SetupSettings so define them again after the operation You can set the Auto PAN, PATTERN, and Auto PlayPosition Direction Left Endless OFF Speed Scan Setup Pattern SetupSelect the Start and move the camera using pan/tilt/zoom Auto Play Setup ~ 511 for PresetYou can set the north direction and the zone coverage Zone SETSelect Main MENU-ZONE SET Alarm SET Select Main MENU-ALARM SET Auto SET Sets the pattern and scan Clock SET Other SETOSD Color Factory DefaultsPassword Proportional P/TYou can check the system information CommunicationSystem Info Select Main MENU-SYSTEM InfoLanguage You can set the language of the user interfaceShortcut Keys Function KeySpecifications Manual Pan Speed 0.01˚~ 180˚/sec Preset Pan Speed 600˚/sec, maximumDescription PAN range 360˚Endless Tilt range -6˚~186˚Product Appearance 00885A-NASCC-C6455N-ENG.indb 2009-08-05 오후