setup
Connect the camera to the keyboard controller or DVR, with which you can manipulate and change the settings of the camera.
How to use the keyboard controller
Follow the steps below to set the camera menu using the controller.
1.Open the Camera Setup screen.
2.Use the joystick to navigate through the menus.
3.Press [ENTER] to select a menu item.
4.Use the joystick to change the value of the selected item.
5.Press [ENTER] to apply your changes.
Using OSD icons
_+: If these icons appear in the left and right corner of a menu item, you can use the joystick to move to the previous or next menu.
(EXIT): Exits the menu setup screen.
Before exiting the setup screen, select <SAVE> to save your settings to the whole menus, or <QUIT> to cancel them.
(RET): Saves your settings and returns to the previous screen.
(HOME): Returns to the main menu.
(SAVE): Use this icon if you want to save your settings after you specified the mask area and privacy area, etc.
Once you saved your settings, the changes remain intact even if you select <QUIT> on exit.
(DEL): Use this icon if you want to delete a mask, or privacy area, etc.
Once you deleted your settings, the deletions remain valid even if you select <QUIT> on exit.
: This icon appears in the right of a menu containing sub menu items.
M | While any operation of PRESET, AUTO PAN, SCAN, and PATTERN is running, and if |
| the camera is turned off and back on without any particular manipulation, the |
| camera will resume the last run operation. |
| You can set the menu item only if the tilt angle is within 90°. |
| If you enter the menu setup screen with the camera positioned out of a tilt of 90°, |
| the camera will rotate by 180° to fall into the opposite position within a tilt of 90°. |
20_ setup