Samsung SCC-C6455N user manual Connecting the adaptor cable, Power Supply, Adaptor Board

Page 19

Connecting the adaptor cable

Adaptor Board

English

Power Supply

Connect the cables as necessary, and turn on the camera to check if it works properly.

1.Connect the adaptor to the power terminal of the camera.

2.Plug the power cord of the adaptor into the wall outlet.

English _19

00885A-NA_SCC-C6455N-ENG.indb 19

2009-08-05 오후 2:43:

Image 19

Contents Smart Dome Camera Overview English Overview FCC Statement Important safety instructions Contents What’s Included FeaturesCamera At a GlanceFrame SET Installation Preparing InstallationInsert the cable into the Frame SET, and close the Adaptor Screw Fixing Hole DiagramProtective Tape from on the lens Button Frame SET Cover Camera Use SW606, SW605, and SW604 to specify the camera address Initial SetupCamera Address Setup Communication Protocol SetupFactory default is 9600 BPS Baud Rate SetupSetting RS-422A/RS-485 Termination Use pins #5, #6 of SW603 to set the baud rateSame address in the network RS-422A/RS-485 Full Duplex OrganizationConnecting to a monitor Connecting with Other deviceVideo terminal on the rear of monitor BNC Cable To connect Alarm OUT To connect AlarmTo connect the controller Power Supply Connecting the adaptor cableAdaptor Board Using OSD icons How to use the keyboard controllerCamera will resume the last run operation Main Menu  ITS ProfileNight VPS You can configure the general settings of the camera moduleCamera SET Camera IDBLC With Backlight set to IrisDNR With this, you can adjust the AGC level of aAGC MotionXDR ShutterSENS-UP FlickerlessDAY/NIGHT You can specify a recording mode according to the sceneAny excessively bright area in a night scene will be MASKed SET-AUTO SET are not available Auto Switch or Auto FocusWhite BAL  You can specify Mask 1 and 2 simultaneouslyDAY/NIGHT Digital Zoom Zoom SpeedDisplay Zoom Display P/TPOSI/NEGA SyncAGC Color SUP ReverseAdvanced You can enable the motion detection and tracking functionsWhen multiple motions continue arbitrarily Intelligent VideoDisplay ResolutionAlarm OUT Privacy ZonePreset Select Position and adjust PAN Select the preset numberSET. pages 24 ~ You can set the Auto PAN, PATTERN, and Auto Play Auto Pan SetupSettings so define them again after the operation Auto SETPosition Direction Left Endless OFF Speed Scan Setup Pattern SetupSelect the Start and move the camera using pan/tilt/zoom ~ 511 for Preset Auto Play SetupYou can set the north direction and the zone coverage Zone SETSelect Main MENU-ZONE SET Select Main MENU-ALARM SET Alarm SET Auto SET Sets the pattern and scan Other SET Clock SETProportional P/T Factory DefaultsPassword OSD ColorSelect Main MENU-SYSTEM Info CommunicationSystem Info You can check the system informationYou can set the language of the user interface LanguageFunction Key Shortcut KeysSpecifications Tilt range -6˚~186˚ Preset Pan Speed 600˚/sec, maximumDescription PAN range 360˚Endless Manual Pan Speed 0.01˚~ 180˚/secProduct Appearance 00885A-NASCC-C6455N-ENG.indb 2009-08-05 오후