Tandberg Data 1080P manual Tandberg PrecisionHD 1080p 12X/4X, Line voltage frequency

TANDBERG PrecisionHD 1080p/720p camera Camera User Guide

Contentsontents

IntroductionIntroduction

PhysicalPhysicaliinterfacet rf

Cablesables

ConnectiConnect toto codec

VideoVideoi forformatsr atsats

Daisyaisy chainingchaining

Appendicesppendices

Contactontact usus

TANDBERG PrecisionHD 1080p 12X/4X

Video output formats

The PrecisionHD 1080p video formats DIP switch table

NOTE: The information on this page applies to the PrecisionHD 1080p 12X/4X camera, and describes how to set the DIP switches 1–5 to configure the camera for different video output formats.

DIP switch settings for video output formats

The DIP switch sets the video output format for the camera. The DIP switch is on the underside of the camera. The default setting is Auto. See the table to the right.

•Maximum resolution for HDMI is:

•1080p60 for PrecisionHD 1080p 12X zoom

•1080p30 for PrecisionHD 1080p 4X zoom

•Maximum resolution for HD-SDI* is 1080p30.

Line voltage frequency

The camera will automatically detect the line voltage frequency when it is 50 or 60 Hz. If there is a different line voltage, you can set the video output format to a specific value (use the DIP switches) to override the auto frequency detection.

Set the PrecisionHD 1080p DIP switch (country specific setting):

•50Hz: 00011, gives 1080p50 (720p50 for HD-SDI)

•60Hz: 00100, gives 1080p60 (720p60 for HD-SDI)

1

0

The DIP switch

Underside side of the TANDBERG PrecisionHD 1080p camera

DIP Switch table for video formats

1	2	3	4	5	HDMI		HD-SDI*
0	0	0	0	0		Auto
0	0	0	0	1	1920x1080p25		1920x1080p25
0	0	0	1	0	1920x1080p30		1920x1080p30
0	0	0	1	1	1920x1080p50		1280x720p50
0	0	1	0	0	1920x1080p60		1280x720p60
0	0	1	0	1	1280x720p25		1280x720p25
0	0	1	1	0	1280x720p30		1280x720p30
0	0	1	1	1	1280x720p50		1280x720p50
0	1	0	0	0	1280x720p60		1280x720p60
0	1	0	0	1	Software control

The table shows the different settings available for the HDMI and the HD-SDI outputs.

Auto: Camera negotiates format over HDMI. HD-SDI tracks HDMI and defaults to 1080p30 in absence of HDMI sync.

Software: For more on the Software control setting, read about video mode selections in the TANDBERG PrecisionHD 1080p User Guide.

* Not supported with Codec C20

D14640.01—MARCH 2010 15 www.tandberg.com