Panasonic TH37PR11UK operating instructions Options Adjustments

Options Adjustments

Item					Adjustments
	Off	PC	INPUT1	INPUT2	INPUT3
	Locks the input switch operation.
	Notes:
	• Only the adjusted signal is displayed (see page 13).
INPUT lock	• Signal can be displayed when the Terminal board is installed.
	• Input switch can be used when this is set to “Off”.

•In two screen display mode, if anything other than “Off” is set, the value will be fixed as the value input in the single screen display mode.

•When a dual input terminal board is attached, A or B is displayed depending on the selected input signal. (Ex. INPUT1A, INPUT1B)

Off MENU&ENTER On

Off: All the buttons on main unit can be used.

MENU&ENTER: Locks and buttons on main unit.

				MENU		ENTER/
Button lock	On: Locks all the button on main unit.
	Sets Button lock with the unit buttons in the following procedure.
	Off: Press		four times→Press				four times→Press		four times→Press
	MENU&ENTER: Press					INPUT		four times→Press		ENTER/
					four times→Press					four times→Press
	On: Press			ENTER/			four times→Press		INPUT		ENTER/
			four times→Press						four times→Press
						ENTER/				ENTER/
	Off	User1		User2		User3
	Off:	You can use all of the buttons on the remote control.
Remocon User level	User1:You can only use				,	, ,	, ,	buttons on the remote control.

User2:You can only use button on the remote control.

User3:Locks all the buttons on remote control.

	Off:	Sets normal two screen display mode (see page 17).
	On:	Sets Advanced PIP mode (see page 18).
Advanced PIP	Notes:
	• When “INPUT lock” is “On”, you cannot use all the two screen display functions.
	• ,	buttons are unavailable during Advanced PIP mode operation.
	Enable:		Enables the “Off-timer function”.
Off-timer function	Disable:		Disables the “Off-timer function”.
	Note:		When “Disable” is set, the Off-timer is cancelled.
	Normal		Standby		On
	Sets the power mode of the unit for when the power recovers from failure or after plugging off and in again.
Initial Power Mode	Normal: Power returns in as the same state as before the power interruption.
	Standby: Power returns in standby mode. (Power Indicator : red/orange)
	On:		Power returns in power On. (Power Indicator : green)
	Note:		When using multiple displays, “Standby” is preferred to be set in order to reduce a power load.
	Sets panel ID number when panel is used in “Remote ID” or “Serial ID”.
ID select	Set value range: 0 - 100
	(Standard value: 0)
	The setting of this menu is valid only when using ID remote control.
Remote ID	Off:	Disables ID remote control functions. You can use normal remote control operations.
	On:	Enable ID remote control functions.
	Sets the panel ID Control.
Serial ID	Off:	Disables external control by the ID.
	On:	Enables the external control by the ID.
	Off		Auto	On
	Off:	Power is not transmitted to the slot power.
Slot Power	Auto: Power is transmitted to the slot power only when main power is on.
	On:	Power is transmitted to the slot power when main power is on or in the standby state.
	Note: In some cases, power is transmitted to the slot power when main power is on or in the standby state
		regardless of the slot power setting.

36