Rockford Fosgate RFX8220, RFX8230, RFX8210 manual IR Remote Troubleshooting, No CD

SYMPTOM	DIAGNOSIS	REMEDY
Error 7	The laser pick-up is	Repair the laser pick-up
(Focus Error)	defective
	Disc is warped,	Put in a new disc
	cracked or damaged
Error 9	Disc is warped,	Eject damaged disc from source
(TOC Error)	cracked or severely	unit and play only non-damaged
	damaged.	discs
	The laser pick-up is	Have a service center repair the
	defective	laser pick-up
NO CD	Magazine is empty or	Check the magazine and insert
(No Disc Error)	not installed in the unit	discs
NO CONN	8-pin DIN cable is	Check the connection of 8-pin
(Communication Error)	disconnected from the	DIN cable between the CDX
	CDX mechanism or	and unit
	source unit

SYMPTOM	DIAGNOSIS	REMEDY
CD Changer does	CDX cable is inter-	Check connections and repair or
not operate	mittent or severely	replace CDX cable as necessary
	damaged
	CDX cable is discon-	Check connections at the Source
	nected from the Source	unit and CD Changer and repair
	Unit or CD Changer	wiring as necessary
	Communication	Press “Reset” button on CD
	problem	Changer
Disc is jammed in	Disc load/unload	Press “Reset” button on CD
the CD Changer	problem	Changer. If CD Changer still
		does not operate, see your Local
		Authorized Rockford Fosgate
		Dealer

IR REMOTE TROUBLESHOOTING

SYMPTOM	DIAGNOSIS	REMEDY
IR Remote has	Batteries are weak	Check battery condition and
poor range		replace as necessary with
		(1) CR2025 (+3 volt) battery
	Excessive dirt or dust	Clean transmitter lens with
	on IR Remote trans-	Plexiglas solution and a non-
	mitter lens	abrasive cloth as necessary
	Excessive dirt or dust	Clean receiver lens (compact disc
	on source unit receiver	logo) with Plexiglas solution and a
	lens	non-abrasive cloth as necessary
	IR remote is outside of	Operate IR remote within approx-
	optimum transmitting	imately 15 ft and ±45˚ from
	range	horizontal of the Source unit’s
		faceplate
	High sunlight	Operate IR remote closer to
	conditions	Source Unit
IR Remote does	Batteries are dead	Check battery condition and
not work		replace as necessary with
(LED does not		(1) CR2025 (+3 volt) battery
illuminate)
	Battery is installed	Check battery installation and
	incorrectly	repair as necessary (polarity is
		indicated on pc board)

– 66 – – 67 –