Step By Step Installation

Rear Seat	Rear/Trunk
	of Car

Figure 2

Figura 2

Abbildung 2

Step 1: Determine where the speaker will be mounted. Make sure there is a flat area large enough for the speaker to fit properly. An uneven mounting surface can damage the driver.

Step 2: Check to make sure the space you have chosen for the speaker will not interfere with the operation of the vehicle.

Step 3: Using a template, mark the speaker hole with a pen.

Step 4: Cut the hole for the speaker. When using factory locations, this step can be passed. A hole can be cut either with a pair of metal tin snips or a hole saw corresponding to the size of the speaker listed below.

•41/8" (105mm) hole saw (4"Coaxial installation)

•43/4" (120mm) hole saw (5.25"Coaxial installation)

•51/8" (130mm) hole saw (6" & 6.5" Coaxial installation)

Step 5: Run the speaker wire to the speakers. Make sure to keep wires away from sharp metal or other edges. When passing through metal ,use a protective grommet.

Step 6: Using the template, mark the mounting holes with a pen.

Step 7: Pre-drill mounting holes using a 1/8" drill bit.

Step 8: Pull the wire through the speaker opening and connect to the speaker.

Step 9: Mount the speaker and grill in the hole using the same screws. Insert the screws through the grill and the mounting holes in the basket.

WARNING: Window mechanisms and electrical wires may be hidden from sight.

CHECK FOR CLEARING BEFORE YOU DRILL!

4	© 2008 directed electronics—all rights reserved