PREPARATION
CONNECTING THE CD CHANGER
Follow these steps to connect the CD changer to your audio system and to power.
Caution: Do not use the receiver/ amplifier’s PHONO inputs. Doing so could damage the receiver/am- plifier.
4.Plug the CD changer’s power cord into a standard AC outlet.
1.Select a location for your CD changer that is near your receiver/ amplifier and a standard AC out- let.
Caution: Do not place the CD changer on top of the receiver/am- plifier or any other component that gets hot.
Note: If you place the CD changer near other audio components or their wires, you might hear a hum when you play a CD. To eliminate the hum, move the components or their wires.
2.Plug one end of the supplied au- dio cable into the CD changer’s LINE OUT L (left) and R (right) out- put jacks, matching the red plug to the red R jack and the white plug to the white L jack.
3.Plug the other end of the cable into the receiver/amplifier’s left and right CD, AUX, or TAPE input jacks.
8
USING THE REMOTE CONTROL
Installing Batteries
Your CD changer’s remote control re- quires two AA batteries (not supplied) for power. We recommend alkaline batteries, such as RadioShack Cat. No.
Cautions:
•Always use fresh batteries of the required size and recommended type.
•Do not mix old and new batteries, different types of batteries (stan- dard, alkaline, or rechargeable), or rechargeable batteries of differ- ent capacities.
1.Pull the latch on the battery com- partment cover and lift it off.