Setting the clock (Remote Control only)
In this example, the clock is set for the
1Press the
2Press the CLOCK/TIMER button.
3Within 10 seconds, press the 
or 
button to select "CLOCK", and press the MEMORY button.
4Press the 
or 
button to select
"0:00" |
| The |
| ||
| (0:00 - 23:59) | |
"AM 12:00" |
| The |
| ||
| ||
|
| (AM 12:00 - PM 11:59) |
"AM 0:00" |
| The |
| ||
| ||
|
| (AM 0:00 - PM 11:59) |
5Press the 
or 
button to adjust the hour and then press the MEMORY button.
Press the 
or 
button once to advance the time by 1 hour. Hold it down to advance continuously.
6Press the 
or 
button to adjust the minutes and then press the MEMORY button.
Press the 
or 
button once to advance the time by 1 minute. Hold it down to change the time in
To confirm the time display:
[When the unit is in the
The time display will appear for about 10 seconds.
[When the power is on]
Press the CLOCK/TIMER button.
Within 10 seconds, press the 
or 
button to display the time. The time display will appear for about 10 seconds.
Note:
The "CLOCK" will appear or time will flash to confirm the time display when the AC power supply is restored after a power failure or unplugging the unit. If incorrect, readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1. If the "CLOCK" does not appear in step 3, step 4 (for selecting the
To change the 24-hour or 12-hour display:
1Clear all the programmed contents. [Refer to "Clearing all the memory (reset)" on page 38 for details.]
2Perform "Setting the clock" from step 1.
Basic Operation
13