Listening to the radio
Auto power on function:
When you press any of the following buttons, the unit turns on. TUNER (BAND) button (main unit and remote control): The unit turns on and the "TUNER" function is activated.
/ 
button on the main unit: The unit turns on and playback of the last function starts (CD,TUNER,VIDEO/AUX/USB).
Note:
This product can receive FM stereo/FM monaural and AM monaural broadcasts. AM stereo broadcasts will not be played in stereo.
Tuning
1Press the
2Press the TUNER (BAND) button repeatedly to select the desired frequency band (FM or AM).
3Press the TUNING (
or 
) button on the remote control to tune in to the desired station.
Manual tuning:
Press the TUNING (
or 
) button as many times as required to tune in to the desired station.
Auto tuning:
When the TUNING (
or 
) button is pressed for more than 0.5 seconds, scanning will start automatically and the tuner will stop at the first receivable broadcast station.
Notes:
When radio interference occurs, auto scan tuning may stop automatically at that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING (
or 
) button again. When an RDS (Radio Data System) station is tuned in, the fre- quency will be displayed first, and then the RDS indicator will light up. Finally, the station name will appear.
Full auto tuning can be achieved for RDS stations "ASPM", see page 28.
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display the "ST" indicator. "
" will appear when an FM broadcast is in stereo.
If the FM reception is weak, press the TUNER (BAND) button to extinguish the "ST" indicator. The reception changes to monaural, and the sound becomes clearer.
FM stereo mode indicator
FM stereo receiving indicator
Radio
25