CD3610 Preparation, Wiring

CD3610

Preparation (continued)

Install Half-Sleeve

1.Install adapter and dash kit if necessary (optional).

2.Install half-sleeve into adapter or dashboard.

3.Push tabs out to secure half-sleeve in the radio opening.

4.Install support strap to make unit more stable.

Wiring

Wiring with a Wiring Adapter (Purchased Separately)

Connect Wires

You can make all these connections without even being in the car.

1.Splice or crimp wires.

2.Attach wiring adapter to car wiring harness.

Wiring Diagram / Color Codes

1.Power Antenna (dark blue wire) - Connect to power antenna or amplifier. If not used, tape bare end of wire.

2.Ground (black wire) - Connect to ground terminal or clean, unpainted part of chassis.

3.Memory/Battery (yellow wire) - Connect to battery or 12 volt power source that is always alive. The radio will not work if this wire is not connected.

4.Accessory/Ignition (red wire) - Connect to existing radio wire or radio fuse.

5.Left front speaker

6.Right front speaker

7.Left rear spearker

8.Right rear speaker

9.RCA Outputs to Amplifier

10.Auxiliary Input Cables

11.Antenna

12.CD Changer

Fuses

	Install Half-Sleeve	Connect Wires
	Instalación de la Camisa	Conecte los cables
	Installation du demi-manchon	Raccordement des fils
		Jensen Connector
		4
	3
		1
		1
		2
	2
	Wiring
	Cableado
	Câblage
	10A
		11
	10
		12
		1
	9
Rear	Gray	2
Posterior

Arrière

Gris / Gris

When replacing a fuse, make sure the new fuse is the correct type and amperage. Using an incorrect fuse could damage radio. The CD3610 uses one 15 amp fuse located below the wiring connector: 15 amp fast blow ATO.

Reconnect Battery

When wiring is complete, reconnect the battery negative terminal.

White/Black (-)

Blanco/Negro (-)

Blanc/Noir (-)

White / Blanco / Blanc (+)

Green/Black (-)

Verde/Negro (-)

Vert/Noir (-)

Gray/Black (-)

Gris / Negro (-)

Gris / Noir (-)

Gray / Gris / Gris (+)

Violet/Black (-)

Violeta/Negro (-)

Violet/Noir (-)

Green / Verde / Vert (+)

Violet / Violeta / Violet (+)