About the remote control, Inserting the batteries

ENGLISH

Cautions on handling

• Before turning the power on

Check once again that all connections are correct and that

there are no problems with the connection cables.

• Power is supplied to some of the circuitry even when the

unit is set to the standby mode. When going on vacation or

leaving home for long periods of time, be sure to unplug the

power cord from the power outlet.

• About condensation

If there is a major difference in temperature between the

inside of the unit and the surroundings, condensation (dew)

may form on the operating parts inside the unit, causing the

unit not to operate properly.

If this happens, let the unit sit for an hour or two with the

power turned off and wait until there is little difference in

temperature before using the unit.

• Cautions on using mobile phones

About the remote control

The supplied remote control can be used to control marantz Integrated Amplifier and marantz Super Audio CD player.

•The remote control may not operate some products.

Inserting the batteries

q Remove the rear lid in the

w Load the two batteries

direction of the arrow and

properly as indicated by

remove it.

the marks in the battery

compartment.

Operating range of the remote control unit

Point the remote control unit at the remote sensor when operating it.

Approx. 26.2ft / 8 m

30° 30°

Using a mobile phone near this unit may result in noise. If

that occurs, move the mobile phone away from this unit

when it is in use.

• Moving the unit

Turn off the power and unplug the power cord from the

power outlet. Next, disconnect the connection cables to

other system units before moving the unit.

• About care

• Wipe the cabinet and control panel clean with a soft cloth.

• Follow the instructions when using a chemical cleaner.

• Benzene, paint thinner or other organic solvents as well as

insecticide may cause material changes and discoloration

if brought into contact with the unit, and should therefore

not be used.

e Put the rear cover back on.

NOTE

•Insert the specified batteries in the remote control unit.

•Replace the batteries with new ones if the set does not operate even when the remote control unit is operated close to the unit. (The supplied batteries are only for verifying operation. Replace them with new batteries at an early date.)

•When inserting the batteries, be sure to do so in the proper direction, following the q and w marks in the battery compartment.

•To prevent damage or leakage of battery fluid:

•Do not use a new battery together with an old one.

•Do not use two different types of batteries.

•Do not attempt to charge dry batteries.

•Do not short-circuit, disassemble, heat or dispose of batteries in flames.

•Do not keep the battery in a place exposed to direct sunlight or in places with extremely high temperatures, such as near a heater.

•If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insert new batteries.

•Remove the batteries from the remote control unit if it will not be in use for long periods.

•Used batteries should be disposed of in accordance with the local regulations regarding battery disposal.

•The remote control unit may function improperly if rechargeable batteries are used.

NOTE

•The set may function improperly or the remote control unit may not operate if the remote control sensor is exposed to direct sunlight, strong artificial light from an inverter type fluorescent lamp or infrared light.

•When using 3D video devices that transmit radio communication signals (such as infrared signals etc) between the various units (such as the monitor, 3D glasses, 3D transmitter unit etc), the remote control unit may not operate due to interference from those radio communication signals. If this occurs, adjust the direction and distance of the 3D communication for each unit, and check that the remote control unit operation is not affected by these signals.