Marantz PM6005 appendix Speaker connection, Connecting the speakers cables

Contents Connections Playback Settings Tips Appendix

Speaker connection

NOTE

•Disconnect this unit’s power plug from the power outlet before connecting the speakers.

•Connect so that the speaker cable core wires do not protrude from the speaker terminal. The protection circuit may be activated if the core wires touch the rear panel or if the + and – sides touch each other (vpage 40 “Protection circuit”).

•Never touch the speaker terminals while the power cord is connected.

•Use speakers with impedances within the ranges shown below to suit how they are used.

Speakers used	Impedance
SPEAKERS A	4 – 16 Ω/ohms
(Standard connection)
SPEAKERS B	4 – 16 Ω/ohms
SPEAKERS A and SPEAKERS B	8 – 16 Ω/ohms
SPEAKERS A and SPEAKERS B	4 – 16 Ω/ohms
(for bi-wiring connections)

Connecting the speakers cables

Carefully check the left (L) and right (R) channels and + (red) and – (black) polarities on the speakers being connected to the unit, and be sure to connect the channels and polarities correctly.

1	Peel off about 3/8 inch (10 mm) of
	sheathing from the tip of the speaker
	cable, then either twist the core wire
	tightly or apply solder to it.
2	Turn the speaker terminal
	counterclockwise to loosen it.

3	Insert the speaker cable’s core wire to all
	the way into the speaker terminal.

4 Turn the speaker terminal clockwise to tighten it.

			15
Front panel	Rear panel	Remote		Index