ContentsConnectionsPlaybackSettingsTipsAppendix
22Operations cannot be performed through the remote control unit
Symptom |
| Cause / Solution |
| Page |
|
|
|
| |
Operations cannot be performed | • Batteries are worn out. Replace with new batteries. |
| 5 | |
through the remote control unit. | • Operate the remote control unit within a distance of about 23 ft/7 m from this unit and at an | 5 | ||
| angle of within 30°. |
|
| – |
| • Remove any obstacle between this unit and the remote control unit. | |||
| • Insert the batteries in the proper direction, checking the q and w marks. | 5 | ||
| • The set’s remote control sensor is exposed to strong light (direct sunlight, inverter type | – | ||
| fluorescent bulb light, etc.). | Move the set to a place in | which the remote control sensor will |
|
| not be exposed to strong light. |
| – | |
| • When using a 3D video device, the remote control unit of this unit may not function due to | |||
| effects of infrared communications between units (such as TV and glasses for 3D viewing). In |
| ||
| this case, adjust the direction of units with the 3D communications function and their distance |
| ||
| to ensure they do not affect | operations from the remote | control unit of this unit. | 30 |
| • Enable the remote signal receiving function. |
| ||
| • Set the combination of this unit and the remote control to the same remote control code. | 31, 32 | ||
|
|
|
|
|
|
|
| 37 |
|
|
Front panel |
|
| Rear panel |
|
| Remote |
| Index |
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|