Contents | Connections | Playback | Settings | Tips | Appendix |
Setting remote control codes
When three of these units are used in the same location, each unit can be controlled independently by setting separate remote control codes.
Be sure to check the operation of each unit after setting the remote control codes.
The default setting is “AMP1”.
REMOTE MODE
CD
Setting remote control codes for the remote control
22To set the remote control codes to AMP2
1 Press and hold REMOTE MODE CD and number button 2 for 5 seconds or longer.
22To set the remote control codes to AMP3
1 Press and hold REMOTE MODE CD and number button 3 for 5 seconds or longer.
ENTER 
1 – 3
NOTE
•To restore the remote control code default setting, press and hold REMOTE MODE CD and number button 1 for 5 seconds or longer.
•The remote control codes returns to the default settings when the batteries are removed. Set the remote control codes again after replacing the batteries.
|
|
|
|
|
|
|
| 31 |
|
|
Front panel |
|
| Rear panel |
|
| Remote |
| Index |
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|