Connecting the 910 Digital Audio Preamplifier
6Connecting the 910 Digital Audio Preamplifier
To connect the 910 as illustrated in the example in Figure 21:
1.Connect the inputs:
•Connect an unbalanced stereo source (for example, a tape recorder) to the left and right INPUT 1 RCA connectors
•Connect an balanced stereo source (for example, a tape recorder) to the left (L+,
•Connect a digital audio source (for example, a digital audio player) to the INPUT 3 S/PDIF RCA connector
•Connect a microphone to the INPUT 4 MIC XLR connector (see Section 6.4). Set the MIC MODE button to Dynamic or Condenser (pressed in)
2.Connect the outputs:
•Connect the left and right OUTPUT 1 RCA connectors to an unbalanced stereo audio acceptor (for example, a power amplifier)
•Connect left (L+,
•Connect the OUTPUT 3 S/PDIF connector to a digital audio acceptor (for example, a digital power amplifier)
3.To remotely operate the 910, make any of the following connections:
•
•Ethernet
•USB connector to a PC (see Section 6.3)
4.Connect the power cord2 (not shown in Figure 2).
1 Switch off the power to each device before connecting it to the 910. After connecting the 910, switch on its power and then switch on the power to each device
2 We recommend that you use only the power cord supplied with this device
9