Caution
1.Use of headphones while operating an automobile or moving vehicle is not recommend- ed and is unlawful in some countries and areas.
2.Be careful and attentive on the road. Stop operation of the Aux2Car adaptor if you fi nd it disruptive or distracting while driving. The driver of a motor vehicle should not operate the Aux2Car ADAPTER while driving.
FCC Class B Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC rules. These limits are designed to provide reason- able protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encourages to try to correct the interference by one or more of the following measures:
1.Reorient or relocate the receiving antenna.
2.Increase the separation between the equipment and receiver.
3.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4.Consult the dealer or an experienced radio/television technician for help.
Notice 1: The changes or modifi cations not expressly approved by the party responsible for compliance could void the user authority to operate the equipment.
Notice 2: Shielded interface cables, if any, must be used in order to comply with the emis- sion limits.
Copyrights, warnings, and other information.
The illustrations, technical information, data and descriptions contained in this publication are subject to change without notice.
This publication, together with all information contained in it, and all intellectual property rights on this publication remain the property of Peripheral Electronics. The user may not pass this publication on to third parties.
No liability will be accepted for any inaccuracies or omissions in this publication, although due care has been taken to make it as complete and accurate as possible
17