Audi

VEHICLE INSTALLATION

Before connecting any cables to the Aux2Car you must set the dip switches to the correct position. If you set the dip-switches after you have connected cables to the interface, you must disconnect and reconnect them for the Aux2Car to operate.

Before connecting any cables to the Aux2Car you must set the dip switchs to the correct position. If you set the dip-switches after you have connected cables to the interface, you must disconnect and reconnect them for the Aux2Car to operate.

DIP SWITCHES MUST BE SET BEFORE YOU PLUG IN THE Aux2Car !!!

1	2	3	4	5	6	7	8
on	off	off	off	off	off	off	on

•All Models (1998-2004) – Pre-wired 13-pin cable in the left-rear trunk of all Audi vehicles use the PXHAD1

•Audi A8 (2003-2004) – Not Compatible.

•Audi A6 (2004) – Not Compatible.

OPERATION

Once you connect the Aux2Car adaptor, turn on your radio. A CD icon will appear on the display of your radio showing that the Aux2Car adaptor is ready to use.

Switch to the Aux2Car adaptor by pressing the CD/ Mode button on the radio.