Peripheral Electronics Acura, DIP Switches Must be SET Before YOU Plug in the Aux2Car

VEHICLE INSTALLATION

Acura

Before connecting any cables to the Aux2Car you must set the dip switches to the correct position. If you set the dip-switches after you have connected cables to the interface, you must disconnect and reconnect them for the Aux2Car to operate.

DIP SWITCHES MUST BE SET BEFORE YOU PLUG IN THE Aux2Car !!!

SETTINGS FOR ALL ACURAS

OPERATION

1	2	3	4	5	6	7	8
on	off	off	on	off	off	off	on

•All Models (1992-2002) – Connector behind the radio, use the PX HCH2 cable and the Aux2Car settings above.

•TL 1999 to 2002 use Honda cable behind the radio

•Acura NSX, SLX, and MDX (1996 and Up) – Not Compatible.

•Acura’s with navigation are not compatible.

Switch to the Aux2Car adaptor by pressing the CD button on the radio. This step may take up to three minutes for the radio to initialize. Some radio models require pressing “Seek >” once to start playing the auxillary source.

4