Clarion CZ309E user manual Troubleshooting, Problem Cause Measure

Car audio and car goods internet store Winauto

8. TROUBLESHOOTING

	Problem	Cause	Measure
	Power does not	Fuse is blown.	Replace with a fuse of the same amperage. If the fuse
	turn on.		blows again, consult your store of purchase.
	(No sound is
		Incorrect wiring.	Consult your store of purchase.
	produced.)
	No sound output	Power antenna lead is	1. Turn the unit off.
	when operating	shorted to ground or	2. Remove all wires attached to the power antenna
	the unit with	excessive current is required	lead. Check each wire for a possible short to
	amplifiers or	for remote-on the amplifiers	ground using an ohm meter.
	power antenna	or power antenna.	3. Turn the unit back on.
	attached.		4. Reconnect each amplifier remote wire to the power
			antenna lead one by one. If the amplifiers turn off
			before all wires are attached, use an external relay
			to provide remote-on voltage (excessive current
			required).
General
	Nothing happens	The microprocessor has	Turn off the power, then press the	Reset button
	when buttons are	malfunctioned due to noise,	[RELEASE] button nd remove
	pressed.	etc.	the DCP
			Press the reset button for about 2
	Display is not		seconds with thin rod.
	accurate.		If the RESET button is pressed
			when a discuais loaded, please
			eject the disc and load it once
			again before attempting to play it.
		DCP or main unit connectors	Wipe the dirt off with a soft cloth moistened with
		are dirty.	cleaning alcohol.
	No sound heard	The spe ker protection circ it	1. Turn down sound volume. Function can also be
		is operating.	restored by turning the power off and on again.
		winauto	(Speaker volume is reduced automatically when
			the speaker protection circuit operates).
			2. If the sound is muted again, consult our service
			department.

English

CZ309 27