Owner’s Manual | DSP8807 | Digital Processor | |
and Amplifier | |||
|
| ||
|
|
|
TELCO PAGING INPUT
CAUTION: Use only with Telephone Equipment that supplies voltages NO GREATER THAN
TELCO PAGIN INPUT
LOOP START
TIP | RING |
Telephone System with Loop Start trunk and DTMF keypad (Touch Tone)
DSP8807 has built in tone generators for audible status for paging; connection to the system responds with ‘single beep’, entering a
page plan number responds with ‘two beeps’.
MEMORY BATTERY REPLACEMENT
CAUTION: If battery is incorrectly replaced explosion can occur. Replace only with the same or equivalent type.
BATTERY
(3v 255mAh 23mm)
++
Remove metal cover (2 screws) and replace Battery as needed with 3V, 255 mAh, 23mm x 3mm size. Typical is Lithium cell coin battery, Panasonic model CR2330
3v
Typical view of
3v cell coin battery
MOUNTING
The DSP8807 unit is designed to mount into standard EIA cabinets, free standing racks, or consoles using the (x4) front slots. NOTE: Allow a minimum one (1) rack space above and below (at 3.5") between the DSP8807 and any other electronic equipment to ensure proper thermal ventilation. This unit may also be mounted on a shelf using the pads provided (x4).
SYSTEM OVERVIEW – SYSTEM HARDWARE / SOFTWARE REQUIREMENTS
The DSP8807 unit has the following hardware and software computer requirements;
•Microsoft Windows Operating system shall be: XP Professional, Windows Vista, Windows 7 or better
•50MB of available hard disk space
•512MB of RAM of higher
•A network connection with a minimum data transfer rate of 10Mbps or higher (100Mbps is recommended).
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800.876.3333 • Fax: 800.765.3435
– 13 – | AtlasSound.com |
Specifications are subject to change without notice.