Atlas Sound DSP8807 specifications Installation Computer Network Termination

Page 9

	Owner’s Manual	DSP8807	Digital Processor
	Owner’s Manual	DSP8807	and Amplifier
			and Amplifier

INSTALLATION

COMPUTER NETWORK TERMINATION

NOTE: All ‘RJ45’ Network connections must be wired to meet EIA/TIA 568B standard.

256

1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.

Telephone: 800.876.3333 • Fax: 800.765.3435

– 9 –

AtlasSound.com

Specifications are subject to change without notice.

Image 9

Contents DSP8807 Digital Processor DSP8807 Introduction Basic Applications Diagram System Overview Signal Flow Diagram EAO CCDtmf EAO Amp O/P PCBDSP8807 TOP Panel DSP8807 RearInstallation Computer Network Termination Audio Line Level Termination 1V/600Ω 70V Speaker TerminationAmbient Sensing Microphone ALM-1 Termination AC Power Input 120VAC @ 60Hz or 240VAC @ 50HzDSP8807 Telco Paging Input Memory Battery ReplacementMounting System Overview System Hardware / Software RequirementsStart UP Settings Start UP ‘SYSTEM’ Masking Noise Settings Noise 1 and 2 VolumeNoise 1 Noise ‘GEQ’ Graphic EQ Noise TRIM/ dB Level Source Inputs Line 1, 2, MUSIC, MIC, NETWORK, TelcoLine 1 and Line 2 Inputs Tone Line 1 and Line 2 Inputs VolumeMusic Input Tone Music Input VolumeMicrophone Input Tone Microphone Input CompressorMicrophone Input ‘PEQ’ / Parametric EQ Microphone Input VolumeNetwork Input ‘PEQ’ / Parametric EQ Network Input ToneTelco Input Compressor Network Input Network VolumeTelco Input Telco ‘PEQ’ / Parametric EQ Telco Input ToneTelco Input Telco Tone Volume Telco Input VolumeMatrix Zone Volume Zone MIX and VolumePlans Monitor Ambient Mics Microphones / ALM-1 DSP RUN ModeSystem Inputs unless noted located on rear panel Specifications System Performance / DSP ProcessorsSystem Mechanical Data System Outputs unless noted located on rear panelTroubleshooting Guide DSP8807 DSP8807 Limited Warranty