MotoSAT Using the Nomad 2 Universal Controller, First Time Installation, Labeled To Nomad

Using the NOMAD 2 Universal Controller

●Dish Pro 500 (300,500,800) Series Receiver(s) are a required component when using the Model MD500.

First Time Installation:

1- Plug in all necessary cable connections to the back of the NOMAD 2 (see diagram on pg. 8). Note: Plugging the receiver and NOMAD 2 controller into an independent power strip is recommended.

2- Connect coax from NOMAD 2 to Mount.

IMPORTANT!!

(Labeled “To Nomad 2)

3- Set the satellite mode to which service you are using by using the Quick Guide for DirecTV, Dish Network, Etc. You will also need to know whether or not your unit is a non-skewableunit [Executive, Freedom], or a skewable unit [MD500, MHDTV]. To get into the satellite mode selector, have the Nomad power off, hold both the Find’ and ‘Stow’ buttons down and hit the Power Button, continue to hold down the Find and Stow button for an additional 5 seconds after power is on. Let go at this point and the front display lights will show the current satellite mode of the unit. Use the ‘Find’ and ‘Stow’ buttons to cycle through the light patterns until the desired configuration is shown. Turn the ‘Power’ off to store the programmed settings. [See page 14 Satellite Mode Guide and page 17 Quick

Guide for configurations and more detailed instructions]

3