WIRING TABLE

Open Face TV Mounts

The Control Cable, 9 conductors, colored coded, 22Awg stranded that connects to the mount with a twist lock connector is configured in the following manner:

 

 

 

 

 

 

 

 

 

 

Color Code

 

Pin Designation

 

Mount

 

Counts

 

 

 

 

 

 

Destination

 

per Degree

 

 

 

 

 

 

 

 

 

 

 

Black

1

 

Motor, Azimuth Positive

 

 

 

 

 

 

 

 

 

 

 

 

 

*Brown

2

 

Motor, Azimuth/Skew

 

 

 

 

 

 

 

 

Negative

 

 

 

 

 

 

 

 

 

 

 

 

 

*Red

3

 

Motor, Elevation/Skew

 

 

 

 

 

 

 

 

Positive

 

 

 

 

 

 

 

 

 

 

 

 

 

Orange

4

 

Motor, Elevation

 

 

 

 

 

 

 

 

Negative

 

 

 

 

 

 

 

 

 

 

 

 

 

Yellow

5

 

Sensor, Count Azimuth

3.408

 

 

 

 

 

 

 

 

 

 

 

Green

6

 

Sensor, Ground

 

 

 

 

 

 

 

 

Azimuth/Elevation

 

 

 

 

 

 

 

 

 

 

 

 

 

Blue

7

 

Sensor Count Elevation

5.034

 

 

 

 

 

 

 

 

 

 

 

White

8

 

Power, Mount LED

 

 

 

 

 

 

 

 

 

 

 

 

 

**Purple

9

 

Sensor, Count Skew

8.500

 

 

 

 

 

 

 

 

 

 

*The Brown and Red wire perform a dual function when used on a Skewable (MD500/MHDTV) mount. They control the Skew motors when directed by the Nomad 2 Controller. Applying 12 volt power directly to these wires will skew the dish.

**The Purple cable is for use on skewable dishes but it WILL NOT effect the operations of a non-skewable dish when it is connected (or not connected).

The Mount is coil wrapped inside with the following cables and wire:

2 ea

RG179 Teflon coated coax cables (can do four (4) if required)

1 ea

Control Cable, 9 conductor cable, colored coded, 22Awg stranded. This cable

 

is molded with a twist lock connector on one end and manually terminated

 

at the other with a 9 pin connector.

2 or 4 ea RG179 coax cables terminate at the LNB to provide availability of cabling for multiple receivers.

1 ea Black and White 22Awg stranded wires carry the positive (white) voltage and ground (black) to the LED which is used to illuminate the dish face.

For any questions or comments please contact our

Technical Support Department at 1-800-247-7486.

13

Page 14
Image 14
MotoSAT Nomad 2 manual Wiring Table, Technical Support Department at