Nomad 2 Quick Guide
We have introduced an exciting new product, the Nomad 2. It has incorporated all the features that you (the dealer and consumer) have asked for. We are excited about it and know that you will be also. To help you become familiar with the programming, and to assist you in the first turn on, we are offering this Quick Guide to programming.
After all connections are made please take the time to read through this guide once and then follow each step as outlined:
TO PROGRAM
Step 1:
Make sure your Nomad 2 is turned OFF:
¾Note: The Nomad 2 is OFF when the green light next to the power button is not lit.
Step 2:
Locate the FIND, STOW and POWER buttons on the Nomad 2:
¾Read the following steps carefully before beginning –
•With your right hand Press and hold down together the FIND and STOW buttons, while continuing to hold…..
•Use your left hand to Press the POWER button once and release
•Your right hand will continue holding down the FIND and STOW buttons for an additional
¾This will put the Nomad 2 into a Program Mode.
Step 3:
Refer to the diagram on page 14 in the Nomad 2 Manual to determine what Program Mode settings you will need for the type of MotoSAT system you have:
¾Use the FIND or STOW button to navigate through the different settings on the front LED panel of the Nomad 2.
¾When the light configuration on the Nomad 2 matches the selected diagram on the page 14, press the POWER button once to turn off the Nomad 2.
¾This will store the configuration that you have set.
Step 4:
Turn on the Nomad 2 by pressing the POWER button. Wait
TO TEST DISH
Step 5:
Complete a “Test Dish” by:
¾Push both the FIND and STOW buttons at the same time.
¾You will see the STOW light blink. It is indicating that the dish is moving.
¾When the Test Dish is completed, the STOW light will stop blinking and go solid.
TO LOCATE SATELLITE Step 6:
Press the FIND button.
¾This will locate your satellite(s) based upon the configuration settings that have been programmed.
Thanks for buying a MotoSAT product.
17
