MotoSAT Nomad 2 manual NON-SKEWABLE Dome or Open Faced mounts, If you are able to go onto the roof

Special Notes

Stowing the dish when all else fails.

If you are able to go onto the roof -

1.Unplug the “Green” 9 pin connector from the back of the NOMAD 2.

2.Go to the roof where you can apply a slight amount of force to move the dish into an acceptable position for traveling.

3.Call Tech Support when you get to a location that you can perform trouble shooting.

If you are unable to go onto the roof –

The dish can be manipulated by applying 12 volt DC power to specific wires in the control cable located in the back of the NOMAD 2. The 12 Volts going to your NOMAD 2 controller (3 pin “green” connector) can be used as this source.

1.ELEVATION - Orange and Red wires (reversing polarity will change direction.)

2.AZIMUTH - Black and Brown (reversing polarity will change direction.)

If a chain or motor/gearbox assembly is broken, the dish will have to be stowed by hand.

Dish Network receivers

NON-SKEWABLE Dome or Open Faced mounts.

If your satellite receiver is a Dish 500 or Dish Pro and you remove it from your home to your RV, you will need to perform a “Check Switch” while the non-skewable dish is in the STOWED POSITION. Your screen upon completion of the “Check Switch” should have 8 X’s in the check boxes meaning that the “Check Switch” failed. This procedure must be

accomplished before you “FIND” satellite. Failure to do so will result in improper operation of the receiver.

11