MotoSAT manual Nomad 2 Universal Controller Rear Panel, Wiring to 9 Pin Control Connector

NOMAD 2 UNIVERSAL CONTROLLER “REAR” PANEL

To Satellite Receiver

Power ConnectorSatellite In

Control Cable

Maintenance Port

From Dish

Power Supply Interface: Is used to connect the 12 VDC 4 AMP power supply to

provide power to the NOMAD 2 Universal Controller. (Note: Only use the power supply provided by MotoSAT or a power source known to have at least a 4 Amp min.)

P1 P2 P3

+12V -GND Unused

Control Cable Interface: Connects the mount by way of a 9 pin conductor cable to the NOMAD 2 Universal Controller. The cable is color coordinated for exact connection configuration. (See Figure Below)

Wiring to 9 Pin Control Connector

Black-Brown-Red-Orange-Yellow-Green-Blue-White-Purple

(Purple is only used on Skewable Mounts, and not required on Non-Skewable Mounts)

7