Atlas Sound DSP8807 specifications Digital Processor

Page 2

DSP8807

Digital Processor

and Amplifier

 

Table of Contents

 

Owner’s Manual

Important Safety Instructions

2

Introduction

4

System Overview Flow Diagram

6

Panel Layout

8

Installation and Endpoint Termination

9

Software Installation and Setup

14

Specifications

31

Troubleshooting Guide

33

Warranty

36

Important Safety Instructions

 

CAUTION

 

RISK OF ELECTRIC SHOCK

 

DO NOT OPEN

ATTENTION

´

-NE PAS OUVRIR.

 

RISQUE DE DECHARGE ELECTRIQUE

WARNING

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

The lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage “ within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product.

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this device near water.

6.Clean only with dry cloth.

7.Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8.Do not install near any heat sources such as radiators, heat registers, stoves, or other devices (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the device.

11.Only use attachments/accessories specified by the manufacturer.

12.Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the device. When a cart is used use caution when moving the cart/device combination to avoid injury from tip-over.

13.Unplug this device during lightning storms or when unused for long periods of time.

14.Refer all servicing to qualified service personnel. Servicing is required when the device has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled, or objects have fallen into the device, the device has been exposed to rain or moisture, does not operate normally, or has been dropped.

15.WARNING: To reduce the risk of fire or electric shock, this device should not be exposed to rain or moisture and objects filled with liquids, such as a vase, should not be placed on this device.

16.To completely disconnect this equipment from the mains, disconnect the power supply cord plug from the receptacle.

17.The mains plug of the power supply cord shall remain readily operable.

 

1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.

 

Telephone: 800.876.3333 • Fax: 800.765.3435

AtlasSound.com

– 2 –

 

Specifications are subject to change without notice.

Image 2
Contents DSP8807 Digital Processor DSP8807 Introduction Basic Applications Diagram Dtmf System Overview Signal Flow DiagramEAO CC Amp O/P PCB EAODSP8807 Rear DSP8807 TOP PanelInstallation Computer Network Termination 70V Speaker Termination Audio Line Level Termination 1V/600ΩAC Power Input 120VAC @ 60Hz or 240VAC @ 50Hz Ambient Sensing Microphone ALM-1 TerminationDSP8807 Mounting Memory Battery ReplacementTelco Paging Input System Overview System Hardware / Software RequirementsStart UP Settings Start UP ‘SYSTEM’ Noise 1 Masking Noise SettingsNoise 1 and 2 Volume Noise ‘GEQ’ Graphic EQ Source Inputs Line 1, 2, MUSIC, MIC, NETWORK, Telco Noise TRIM/ dB LevelLine 1 and Line 2 Inputs Volume Line 1 and Line 2 Inputs ToneMusic Input Volume Music Input ToneMicrophone Input Compressor Microphone Input ToneMicrophone Input Volume Microphone Input ‘PEQ’ / Parametric EQNetwork Input Tone Network Input ‘PEQ’ / Parametric EQNetwork Input Network Volume Telco Input CompressorTelco Input Tone Telco Input Telco ‘PEQ’ / Parametric EQTelco Input Volume Telco Input Telco Tone VolumeMatrix Zone MIX and Volume Zone VolumePlans DSP RUN Mode Monitor Ambient Mics Microphones / ALM-1Specifications System Performance / DSP Processors System Inputs unless noted located on rear panelSystem Outputs unless noted located on rear panel System Mechanical DataTroubleshooting Guide DSP8807 DSP8807 Limited Warranty