2. CABLE CONNECTION
4Lead the power cord and signal cable into the cable holder at rear of the monitor.
NOTE
•The cables are recommended to lead with slight sag for the smooth motion of the stand.
5Adjust the "height", "front and back position" and "angle" of the monitor.
1.Adjust the height of the monitor. To heighten, push the monitor backward. To lower, pull the monitor forward.
Grip both side of the center part | Move slowly |
of the monitor and move slowly |
|
(refer to the right figure.) |
|
Both Side of Center
Part of the Monitor
2.Adjust the position and angle of the monitor. To adjust the angle of the monitor, hold the stand with one hand and tilt the monitor with another hand by holding the upper side of the cabinet.
3. If necessary, fine adjust the height of the monitor.
14