Installation
English
Accessories
External view
......... Number of items
1
........1
2
........1
Installation Procedure
1.To prevent short circuits, remove the key from the ignition and disconnect the - terminal of the battery.
2.Make the proper input and output cable connections for each unit.
3.Connect the wiring harness cables in the following order: ground, battery, ignition.
4.Connect the wiring harness connector to the unit.
5.Install the unit in your car.
6.Reconnect the - terminal of the battery.
7.Press the reset button.(See p. 4)
3
........1
4
........2
5
........1
6
........2
7
........1
8
........6
9
........1
0
........2
2CAUTION
2CAUTION
•If your car's ignition does not come with an ACC position, connect the ignition cables to a power source that can be turned on and off with the ignition key. If you connect the ignition cable to a power source that receives a constant
voltage supply, as with battery cables, the battery may die.
•If the fuse blows, first make sure that the cables have not caused a short circuit, then replace the old fuse with one with the same rating.
•Do not let unconnected cables or terminals touch metal on the car or anything else conducting electricity. To prevent short circuits do not remove the caps from unused terminals or from the ends of the unconnected cables.
•After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly.
•Insulate unconnected wires with vinyl tape or other similar material.
•Mount the unit so that the mounting angle is 30° or less.
The use of any accessories except for those provided might result in damage to the unit. Make sure only to use the accessories shipped with the unit, as shown above.
Installation of Monior Unit
2CAUTION
When mounting the main unit after checking the operation, close the monitor first.
NOTE
•Move the fittings on both sides to suit the installation chassis and select the embedding position from among the 3 positions.( 
:Fixing screw)
•When the fittings are set closest to the front (i.e., the embedding position is farthest back), use the hard rubber frame (Accessory 5).
Accessory 5 | Accessory 9 |
30 |