Pioneer AVH-P5950DVD installation manual Installation, DIN Front/Rear-mount

Installation

Note:

•Check all connections and systems before final installation.

•Do not use unauthorized parts. The use of unauthorized parts may cause malfunctions.

•Consult with your dealer if installation requires drilling of holes or other modifications of the vehicle.

•Do not install this unit where:

—it may interfere with operation of the vehicle.

—it may cause injury to a passenger as a result of a sudden stop.

•Do not install the display where it may (i) obstruct the driver’s vision, (ii) impair the per- formance of any of the vehicle’s operating sys- tems or safety features, including air bags, haz- ard lamp buttons or (iii) impair the driver’s abili- ty to safely operate the vehicle.

•The semiconductor laser will be damaged if it overheats. Install this unit away from hot places such as near the heater outlet.

•Optimum performance is obtained when the unit is installed at an angle of less than 30°.

30°

•The cords must not cover up the area shown in the figure below. This is necessary to allow the amplifires to radiate freely.

Do not cover this area.

•Make sure you leave enough gap between the dashboard and the LCD panel of this unit so the LCD panel can be opened and closed without contacting with the dashboard.

Dashboard

Leave gap

LCD panel

•When installing, to ensure proper heat dispersal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not blocking the vents.

DIN Front/Rear-mount

This unit can be properly installed either from “Front” (conventional DIN Front-mount) or “Rear” (DIN Rear- mount installation, utilizing threaded screw holes at the sides of unit chas- sis). For details, refer to the following illustrated installation methods.

11

<CRD4215-A> 12

ENG/MASTER 96 INST