Pioneer AVH-P5950DVD installation manual Connecting the Units, Contents

Page 2

Contents

 

Connecting the Units

1

Connecting the power cord

3

When connecting to separately sold power

 

amp

5

When connecting with a rear view camera

7

When connecting with a multi-channel

 

processor

8

Connecting and installing the optical cable

 

connection box

9

When connecting the external video

 

component and the display

10

Installation

11

DIN Front/Rear-mount

11

DIN Front-mount

12

DIN Rear-mount

13

Fastening the front panel

14

Installing the remote control unit

14

WARNING

To avoid the risk of accident and the potential violation of applicable laws, the front DVD or TV (sold separately) feature should never be used while the vehicle is being driven. Also, Rear Displays should not be in a location where it is a visible distraction to the driver.

In some countries or states the viewing of images on a display inside a vehicle even by persons other than the driver may be illegal. Where such regulations apply, they must be obeyed and this unit’s DVD features should not be used.

1

Connecting the Units

CAUTION

PIONEER does not recommend that you install or service your display your- self. Installing or servicing the product may expose you to risk of electric shock or other hazards. Refer all installation and servicing of your display to autho- rized Pioneer service personnel.

Secure all wiring with cable clamps or electrical tape. Do not allow any bare wiring to remain exposed.

Do not drill a hole into the engine com- partment to connect the yellow lead of the unit to the vehicle battery. Engine vibration may eventually cause the insu- lation to fail at the point where the wire passes from the passenger compartment into the engine compartment. Take extra care in securing the wire at this point.

It is extremely dangerous to allow the display lead to become wound around the steering column or gearshift. Be sure to install the display in such a way that it will not obstruct driving.

Make sure that wires will not interfere with moving parts of the vehicle, such as the gearshift, parking brake or seat slid- ing mechanism.

Do not shorten any leads. If you do, the protection circuit may fail to work properly.

WARNING

LIGHT GREEN LEAD AT POWER CONNEC- TOR IS DESIGNED TO DETECT PARKED STATUS AND MUST BE CONNECTED TO THE POWER SUPPLY SIDE OF THE PARK- ING BRAKE SWITCH. IMPROPER CONNEC- TION OR USE OF THIS LEAD MAY VIO- LATE APPLICABLE LAW AND MAY RESULT IN SERIOUS INJURY OR DAMAGE.

<CRD4215-A> 2

ENG/MASTER 96 INST

Image 2
Contents Installation Manual CRD4215-AConnecting the Units ContentsMax mA, 12 V DC. If the vehicle is Connecting the power cord LeftFrançais Italiano Nederlands PyÒÒÍËÈ When connecting to separately sold power amp Front OutputLeft Right When connecting with a rear view camera CameraWhen connecting with a multi-channel processor Français ItalianoConnecting the optical cable When connecting the external video component and the display Installation DIN Front/Rear-mountBefore installing the unit DIN Front-mountInstall the unit into the dash- board DIN Rear-mountInstalling the remote control unit Fastening the front panel連接本機 注意: 連接電源線 連接方法 連接另售的功率放大器 藍色/白色功率放大器 (另售) 帶RCA插頭的連接線(另售) 系統遙控 連接後視攝像頭 當本機和備用錄影機一起使用時,可以在變速杆移到REVERSER位置時自動從 後視攝像頭切換為視頻。連接多通道處理器 光纜連接盒的連接和安裝 安裝光纜連接盒連接外部視頻組件和顯示器 使用連至後置視頻輸出的顯示器DIN前面 /後面安裝 注意︰DIN 前面安裝 DIN 後面安裝 安裝遙控器 固定前面板장치의 연결 장치의 연결English Español Français Italiano Nederlands 전원 코드의 연결 오른쪽Nederlands 별도 판매되는 파워 앰프와 연결할 때 DEQ OutputRCA 케이블별매 에 연결합니다 시스템 리모컨 전면 스피커 후면 스피커 서브우퍼 파워 앰프 별도 판매 오른쪽 후방 주시 카메라와 연결할 때 Rear View Camera멀티 채널 프로세서와 연결할 때 15 cm광케이블 연결 광케이블 커넥션 박스의 연결과 설치광케이블 커넥션 박스의 설치 외부 비디오 기기 및 디스플레이와 연결할 때 리어 비디오 출력에 연결된 디스플레이를 사용하는 경우DIN 전면/후면 장착 방식 사이드 브래킷의 위치를 결정합 니다 DIN 전면 장착기기를 설치하기 전에 브래킷의 구멍과 기기 측면의 구멍이 일치하는 적절한 위치로 맞춥니다 DIN 후면 장착기기를 대시보드에 장착하는 방 측면의 각각 두 개의 나사를 체결합니다 리모컨의 설치전면 패널의 고정 Pioneer Corporation