Before installing the unit
•Remove the trim ring and the mounting sleeve.
Extend top and bottom of the trim ring
outwards to remove the trim ring. And then loosen the screws (2 mm ⋅ 3 mm) to remove the mounting sleeve.
•When reattaching the trim ring, push the trim ring onto the unit until it clicks after reattaching the mounting sleeve. (If the trim ring is attached upside down, the trim ring will not fit properly.)
DIN Front-mount
1.Decide the position of the side brackets.
•When installing in a shallow space, change the position of side brackets (small). In this case, stick concealing tape on parts that protrude from the dashboard.
English
Mounting sleeve
Screw (2 mm ⋅ 3 mm)
| Concealing tape |
| Side bracket (small) |
| Flush surface screw (5 mm ⋅ 6 mm) |
Trim ring | • If you prefer an |
| in which the front panel is pushed |
| further back, when there is a space |
| available at the back of the unit, use |
| the side brackets (large). |
Side bracket (large)
Flush surface screw (5 mm ⋅ 6 mm)
<CRD4215-A> 13
Français Italiano Nederlands PyÒÒÍËÈ
12
ENG/MASTER 96 INST