Pioneer AVD-W8000 owner manual Installation

Page 33

Installation

CAUTION

•For instructions on how to mount the display, consult your dealer.

•Certain state laws may prohibit or restrict the placement and use of this sys- tem in your car. Please comply with all applicable laws and regulations regarding the use, installation and operation of your display.

•Do not install the display where it may (i) obstruct the driver’s vision, (ii) impair the performance of any of the vehicle’s operating systems or safety features, including airbags, or (iii) impair the driver’s ability to safely oper- ate the vehicle.

•PIONEER does not recommend that you install or service your display your- self. Installing or servicing the product may expose you to risk of electric shock or other hazards. Refer all installation and servicing of your display to authorized PIONEER service personnel.

•If this product is installed in a place where it is visible to the vehicle’s driver, you MUST always set the [DISPLAY SETTING] to the [FRONT] setting. Failure to do so could result in distracting images being potentially visible to the driver while the vehicle is in motion.

If this product is installed in a place where it is not visible to the vehicle’s driver, then you may choose the [REAR] location setting.

Use of this product is subject to any local laws regarding placement or use. PIONEER Corporation cannot accept any liability for any problems, dam- age or loss incurred as a result of the product being used with an incorrect setting or in violation of any local laws.

•Install the display between the driver’s seat and front passenger seat so that it will not be hit by the driver or passenger if the vehicle brakes sharply.

•Do not install the display in a position where the fully opened air bag will be obstructed by it.

•Do not install the display in a place where it will impair the performance of any of the vehicle’s operating systems, including airbags.

•Make sure there is nothing behind the panelling when drilling holes in them. Be careful not to damage fuel lines, brake lines or power cables.

•When using screws, do not allow them to come into contact with any electri- cal lead. Vibration may damage wires, leading to a short circuit or other damage to the vehicle.

•It is extremely dangerous to allow the display lead to become wound around the steering column or shift lever. Be sure to install the display in such a way that it will not obstruct driving.

•Make sure that leads cannot get caught in a door or the sliding mechanism of a seat, resulting in a short circuit.

ENGLISH ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS

32

Page 32 Page 34
Image 33
Page 32 Page 34
Contents AVD-W8000 Contents We Want You Listening For a Lifetime About Your Color Display… After-sales Service for Pioneer ProductsImportant Safeguards When viewing is difficult, use Bright and Dimmer to adjust Before Using This productTo avoid battery exhaustion Portable phone usage precautionsComponent Parts and Features Using the DisplayTurn On Power Switch on the car engineTurn on the system Setting the Display Mouting Location Display the Display Setting screenDisplay a menu screen Complete the setting Choose item LocationChoose the display mounting location English Español Deutsch Français Italiano Nederlands Selecting Audio and Video Selecting Audio, Video, and Video OutputSelect audio, video and video output About the RCA video and Audio Outputs of this unit About the Selector buttonSet so that only the built-in speaker audio can be switched Switching the Video and Built-in Speaker AudioSet so that only the video can be switched Press the SP.SEL buttonVolume Adjustment Adjust the speaker volumePress the V.SEL button Changing the Way the Wide Screen Enlarges Display video to view Refer to page 11 Select a wide modeWide Modes Available Select a setup menu Adjusting the screenBasic Operations on the Menu Screen Display the menu screenModify the setting Continue with or exit the setupSelect an item Display the video to adjust Picture Adjust BRIGHT/CONTRAST/COLOR/HUESelect an item to adjust Adjust the itemDisplay a menu screen Refer to Choose Dimmer Picture Adjust DimmerAdjust brightness Display a menu screen Refer to Display Input Setting Input Setting VCR1/VCR2Select a connection mode Choose between VCR1 and VCR2Handling the Display About the DisplayAbout the Liquid Crystal Display LCD Screen Keeping the Display in Good ConditionAbout the Small Fluorescent Tube Connecting the System To Prevent Damage Before Installing the UnitNames and Functions of Connection Terminals ACC Connecting the Power CableDisplay Unit Hooking Up the SystemVCR1 Input VCR2 Input Connecting RCA Audio and Video Output Installation Before Installing and Fixing Installing the Hide-away unitBefore affixing the adhesive tape Reset Button SpecificationsPressing the Reset Button Importantes Mesures DE Table des matièresCher Client Propos de l’écran couleur Service après-vente des produits PioneerImportantes Mesures DE Securite Comment éviter de décharger la batterie Avant de vous servir de cet appareilPrécautions d’utilisation du téléphone portable Comment protéger l’écran à cristaux liquidesComposants et particularités Utilisation de l’écranMise sous tension Démarrez le moteur de la voitureAllumez le système Configuration de l’emplacement de l’écran Affichez l’écran Display SettingAffichez un écran de menu Choisissez l’emplacement pour l’écran Choisissez l’option LocationTerminez le réglage Avertissement Comment sélectionner l’audio et la vidéo Sélection du son, de la vidéo et de la sortie vidéoSélectionnez le son, la vidéo et la sortie vidéo Propos des sorties audio et vidéo Cinch de cet appareil Quelques mots concernant la touche de Selector sélectionCommutation de la vidéo et du son du haut-parleur incorporé Appuyez sur la touche SP.SELFaites en sorte que seule la vidéo puisse être commutée Réglage du volume Réglez le volume du haut-parleurAppuyez sur la touche V.SEL Changement du mode d’agrandissement de l’écran Modes d’agrandissement disponibles Comment mettre au point l’écran Sélectionnez un menu de configurationOpérations de base dans l’écran de menu Affichez l’écran de menuPoursuivez ou stoppez la configuration Sélectionnez une optionChangez le réglage Affichez la vidéo à régler Réglage de l’image BRIGHT/CONTRAST/COLOR/HUEAffichez un écran de menu voir Sélectionnez le paramètre à réglerAffichez un écran de menu voir Choisissez Dimmer Réglage de l’image DimmerRéglez la luminosité Sélectionnez un mode de connexion Affichez un écran de menu voir Affichez Input SettingChoix de l’entrée VCR1, VCR2 Choisissez VCR1 ou VCR2Maniement de l’écran Remarques à pr opos de l’écranPropos de l’écran à cristaux liquides LCD Entretien de l’écranPropos du petit tube fluorescent Branchement du système Pour éviter des dégâts Avant d’installer l’unitéNoms et fonctions des prises de raccordement English Français Branchement du cordon d’alimentationAudio Gauche Raccordement du systèmeEnglish Français Deutsch Français Connexions audio Cinch et sortie vidéo Installation Avant l’installation et la fixation Installation de l’unité principaleAvant d’employer le ruban adhésif Touche de réinitialisation Fiche techniqueComment utiliser la touche de réinitialisation Pioneer Corporation
Top Page Image Contents