Bosch Appliances UML-192-90, UML-202-90, UML-172-90 installation manual Selv

Page 11

High Performance LCD Monitors

Safety en

7

 

 

 

Permanently connected equipment - Incorporate a readily accessible disconnect device in the building installation wiring. Pluggable equipment - Install the socket outlet near the equipment so it is easily accessible.

Power disconnect - Units have power supplied whenever the power cord is inserted into the power source. The power cord is the main power disconnect for all units.

Power lines - Do not locate the camera near overhead power lines, power circuits, or electrical lights, nor where it may contact such power lines, circuits, or lights.

SELV

All the input/output ports are Safety Extra Low Voltage (SELV) circuits. SELV circuits should only be connected to other SELV circuits.

Because the ISDN circuits are treated like telephone-network voltage, avoid connecting the SELV circuit to the Telephone Network Voltage (TNV) circuits.

Video loss - Video loss is inherent to digital video recording; therefore, Bosch Security Systems cannot be held liable for any damage that results from missing video information. To minimize the risk of lost digital information, Bosch Security Systems recommends multiple, redundant recording systems, and a procedure to back up all analog and digital information.

NOTICE!

i

This is a class A product. In a domestic environment this

 

 

product may cause radio interference, in which case the user

 

may be required to take adequate measures.

 

 

FCC & ICES INFORMATION

(U.S.A. and Canadian Models Only, CLASS A)

This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions:

this device may not cause harmful interference, and

this device must accept any interference received, including interference that may cause undesired operation.

Note

Bosch Security Systems, Inc.

Installation Manual

F.01U.076.723 3.0 2009.03

Image 11
Contents High Performance LCD Monitors Page Table of Contents Navigating the Monitor Power ManagementPower Consumption LED Indicator Maintenance TroubleShooting GuideImportant Safety Instructions SafetyEn Safety High Performance LCD Monitors High Performance LCD Monitors Safety en Important Notices Safety PrecautionsCommunications Coax groundingThis device is intended for use in public areas only En Safety High Performance LCD Monitors Selv Classe a Informations FCC ET Ices commercial applicationsDisclaimer Trademarks CopyrightCustomer Support and Service Warranty and more information Quantity Part Parts ListUnpacking Number Button Description Exploded ViewBottom Panel Number Connector Side Panel Number ConnectorButton Function Remote ControlPress this button to change the selection Remote Control Battery InstallationSelects the AV mode AV1, AV2, S-Video. Continuously Slide the battery cover back into placeEn Unpacking High Performance LCD Monitors Description Features100 to 240 40 W PowerMin Degree Max Degree 25 122 mm 50 192 mm Installing the MonitorVentilation Mounting the MonitorWall Mount Installation Connecting the Composite Video Signal to the MonitorGND Connecting the Y/C S-Video Signal to the MonitorConnecting Audio to the Monitor Number InputPin Description Connecting the PC Signal to the MonitorNumber Description Connecting an Alarm TriggerExample Typical Alarm Trigger Configuration AV1 Configure the following settings for the Dinion cameraVMD OSD Video AV2 OUT Single / Multiple Monitor ConfigurationVideo Video AV2 OUT VCREn Installing the Monitor High Performance LCD Monitors Navigating the Monitor On-screen Display OSD Navigating the MonitorNavigating the Front Panel En Navigating the Monitor High Performance LCD Monitors Custom Menu On-screen Display MenusSubmenu Definition Custom Brightness Contrast Move Input Menu3D Comb Move Input Menu Picture / Sound MenuDNR Submenu Definition Size Position Swap Sound Select Main Move Input Menu PIP MenuPIP Input SourceSetup Menu Submenu Definition Setup MenuMove Input Menu Buzzer Trigger Time Trigger Option Display TypePIP & Full Component VideoConfiguring Auto Switching Hdmi DVI Selecting Input Sources for Auto SwitchingAV1 AV2 Video ComponentLED Indicator Power ManagementPower Consumption En Power Management High Performance LCD Monitors Maintenance En Maintenance High Performance LCD Monitors Problem Solution TroubleShooting GuideEn TroubleShooting Guide High Performance LCD Monitors Page Europe, Middle East, Africa Bosch Security Systems B.V