30 en Navigating the Monitor | High Performance LCD Monitors |
|
|
control. Use the front panel of the monitor or respective remote control to make any necessary adjustments to the OSD.
NOTICE! When you are navigating through the OSD menus, use
i the Input button to select a menu and use the Menu button to exit a menu.
To navigate the set up menus, follow the steps below:
1.Connect the CVBS or VGA cable.
2.If required, press the Input button until a signal is displayed. NOTE: Menus are not available without a signal applied.
3.Press the Power button to turn on the unit (see Figure 2.1 or Figure 2.2).
4.Press the Menu button to activate the main menu selections (see Figure 2.1 or Figure 2.2).
5.Press the and buttons to select a menu.
6.Press the Input button to enter the selected menu.
7.Press the and buttons to select a
8.Press the and buttons to toggle the OSD values.
9.Press the Menu button to exit the selected menu and to return to the menu bar or to confirm a selection.
10.Press the Menu button again to exit the OSD menu bar.
F.01U.076.723 3.0 2009.03 | Installation Manual | Bosch Security Systems, Inc. |