Bosch Appliances UML-192-90, UML-202-90 Connecting the Composite Video Signal to the Monitor

22 en Installing the Monitor High Performance LCD Monitors

4.2.2Wall Mount Installation

The square mounting holes (100 mm [3.9 in.] centers) are compatible with the Bosch UMM-LW-20B fixed wall mount or the UMM-LW-30B swivel/tilt mount.

Figure 4.1 Mounting the Device

4.3Connecting the Composite Video Signal to the Monitor

There are two (2) BNC connectors located on the rear side panel of the monitor for composite video input and two (2) BNC connectors for composite video outputs (see Figure 2.3). Note: All video inputs are passive loop-through. The impedance is automatically set to 75 ohm by the input of the signal on the input connector, while operating in a single connection mode (see Figure 4.7). If a cable is also connected to the output connector, the video signal can be passed on to another monitor connected to it via the passive loop-through function. Up to three (3) monitors may be connected in this manner (see Figure 4.8).

F.01U.076.723 3.0 2009.03 Installation Manual Bosch Security Systems, Inc.