Clarion VRX925VD owner manual Removing the Main Unit

6. REMOVING THE MAIN UNIT

1.	When the rear of the main unit has been se-	pull the main unit out by the hook plate. (In-
	cured with the method shown in Figure 6 un-	sert both the right and left edges of the hook
	fasten the special screw.	plate.) (Figure 9)
2.	Remove the outer escutcheon.
3.	Insert the hook plate between the spring and	Note: Keep the hook plate. You cannot remove the
	the universal mounting bracket, fit tab B of	main unit without disengaging the hook plate.
	the spring into hole A of the hook plate, then

Installation and Wire English connection manual

Universal mounting bracket	Instrument panel
2-Hook plate
	Main
	Unit
	Spring

Outer escutcheon

A B

Figure 9

7. CAUTIONS ON WIRING

1.Be sure to turn the power off before wiring.

2.Be particularly careful where you route the wires.

Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.

3.If the fuse should blow, check to see if the wiring is correct.

If it is, replace the fuse with a new one with the same amperage rating as the original.

4.To replace the fuse, remove the old fuse of the power supply lead and insert the new one. (Figure10)

∗Power supply lead for the tuner amp unit : 15A

FUSE

∗Power supply lead for the main unit : 3A FUSE

Note: There are various types of fuse holder. Do not let the battery side touch other metal parts.

CAUTION

After the connection, fix the lead by a clamp or insulation tape for protection.

Fuse

Fuse holder

Figure 10

VRX925VD 69