Clarion VRX935VD Basic Operations, Turning on and off the power, Selecting a mode, English

11. OPERATIONS

Basic Operations	Note: Be sure to read this chapter referring to the front diagrams of
	chapter “3. CONTROLS” on page 5 (unfold).

English

CAUTION

When the unit is turned on, starting and stopping the engine with its volume raised to the maximum level may harm your hearings. Be careful about adjusting the volume.

Note:

• Use this unit after starting the engine.

ACC or engine

ON position

Turning on and off the power

Note:

•Be careful about using this unit for a long time without running the engine. If you drain the car’s battery too far, you may not be able to start the engine and this can reduce the service life of the battery.

1.Press the [FUNC] button.

2.The illumination and display on the unit light up. The unit automatically remembers its last operation mode and will automatically switch to display that mode.

3.Press and hold the [FUNC] button for 1 sec- ond or longer to turn off the power for the unit.

Note:

•About the “SYSTEM CHECK”

The confirmation of connected equipment must be performed for this unit only when the wiring connection is complete and power is turned on to the unit first. When the power is supplied, “PUSH PWR” appear in the display. Press the [FUNC] button, the system check starts inside the unit. When “COMPLETE” and “PUSH PWR” appear al- ternately, press once again the [FUNC] button.

Selecting a mode

1.Press the [FUNC] button to change the mode of operation.

2.Each time you press the [FUNC] button, the mode of operation changes in the following order:

Radio mode ➜ SIRIUS mode ➜ DVD mode

➜CD changer mode ➜ MD changer mode

➜DVD changer mode ➜ TV mode ➜ VI- SUAL mode ➜ Radio mode...

∗External equipment not connected with CeNET is not selected.

Adjusting the volume

1.Operate the [VOL] button in the direction of the + (up) or – (down) to adjust the volume;

+: Increases the volume.

–: Decreases the volume.

∗The volume level indicated in the display is in a range from 0 (minimum) to 33 (maximum).

CAUTION

While driving, keep the volume at a level at which external sounds can be heard.

Switching the display

When the panel is closed:

1.Press the [DISP] button to select the desired display.

Each time you press the [DISP] button, the display switches in the following order:

MAIN Display

SUB Display

Clock Time Display

MAIN Display

Notes:

•Once selected, the preferred display becomes the default display. When a function adjustment such as volume is made, the display momentarily switches to that function’s display, then returns back to the preferred display several seconds af- ter the adjustment.

•If a title has been input, it is shown in the SUB display. If no title has been input, “NO TITLE” ap- pears in the display. To input a title, refer to the subsection “Entering titles” in “Other Functions” section.

•For CD, MD and TV, some special characters of the title will not be displayed on the Information Panel of the DCP. In this case, those characters will only be left blank.

Owner’s manual

VRX935VD 21