Advantech IPPC-9151 Series user manual Multiple Monitors

Multiple Monitors

Multiple Monitors supports from two to six touch screen displays for one system. The PenMount drivers for Windows 2000/XP support Multiple Monitors. This function supports from two to six touch screen displays for one system. Each monitor requires its own PenMount touch screen control board, either installed inside the display or in a central unit. The PenMount control boards must be connected to the computer COM ports via the RS-232 interface. Driver installation procedures are the same as for a single monitor. Multiple Monitors supports the following modes:

Windows Extend Monitor Function Matrox DualHead Multi-Screen Function nVidia nView Function

NOTE:	The Multiple Monitors function is for use with
	multiple displays only. Do not use this function
	if you have only one touch screen display.
	Please note once you turn on this function the
	Rotating function is disabled.

Enable the multiple display function as follows:

1.Check the Enable Multiple Monitor Support box; then click Map Touch Screens to assign touch controllers to displays.

57 Appendix8