Elo TouchSystems 2400LM manual Installing the USB Touch Driver

Page 31

Installing the USB Touch Driver

Installing the USB Touch Driver for Windows 7, Windows Vista, Windows XP,

Windows 2000, ME and Windows 98.

1Insert the Elo CD-ROM in your computer’s CD-ROM drive.

If Windows 98 or Windows 2000 starts the Add New Hardware Wizard, do the following:

2Choose Next. Select “Search for the best driver for your device (Recommended)” and choose Next.

3When a list of search locations is displayed, place a checkmark on “Specify a location” and use Browse to select the \EloUSB directory on the Elo CD-ROM.

4Choose Next. Once the Elo USB touchscreen driver has been detected, choose Next again.

5You will see several files being copied. Insert your Windows 98 cd if prompted. Choose Finish.

If Windows 98 or Windows 2000 does not start the Add New Hardware Wizard, do the following:

NOTE: For Windows 2000 you must have administrator access rights to install the driver.

1Insert the Elo CD-ROM in your computer’s CD-ROM drive. If the AutoStart feature for your CD-ROM drive is active, the system automatically detects the CD and starts the setup program.

2Follow the directions on the screen to complete the driver setup for your version of Windows.

If the AutoStart feature is not active:

1Click Start > Run.

2Click the Browse button to locate the EloCd.exe program on the CD-ROM.

3Click Open, then OK to run EloCd.exe.

4Follow the directions on the screen to complete the driver setup for your version of Windows.

2-18

Image 31
Contents Touchmonitor User Guide Revision C Elo TouchSystems LCD Touchmonitor User GuideCopyright 2010 Tyco Electronics. All Rights Reserved Page Page Patient Environment DefinitionsEnvironmental conditions for transport and storage ClassificationStandards EN 60601-1-2 2001+A12004 European Standards and ClassificationsCispr Mains interruptions, it is recommended that Portable and mobile RF communications equipment Xii Table of Contents Product Description IntroductionExternal Medical Grade Power Supply LCD Display Performance FeaturesTFT LCD Display Panel Unpacking Your Touchmonitor Installation and SetupProduct Overview Base Bottom View KensingtonTM Lock Page Remove the Cable Cover Touch Interface ConnectionConnecting the Video Cable Connecting the Serial and USB Touchscreen Cable Connecting the Speaker Cable Connecting the Power Cable Replace the Cable Cover Screw holeVesa mounting interface location, pedestal removedˆ Mounting the DisplayVesa Mounting Options Rear Mounting Using the Vesa InterfaceErgotron Innovative Office Products Optimizing the LCD Display Installing the Touch Driver SoftwareClick Start Run Installing the Serial Touch DriverInstalling the Serial Touch Driver for MS-DOS and Windows Installing the USB Touch Driver Operation About Touchmonitor AdjustmentsSelect Power SwitchBottom Panel Controls Control Function Menu/ExitOSD Locking and Unlocking Feature Controls and AdjustmentOSD Menu Functions OSD Control Options Power Mode Consumption Power Display & Power SavingDisplay Angle Solutions to Common Problems TroubleshootingProblem Suggestions InputVideo 24 LCD Native ResolutionPage Touchmonitor Safety Waste Electrical and Electronic EquipmentWEEE Directive Care and Handling of Your TouchmonitorDisplay Modes Technical SpecificationsDisplay Mode Touchmonitor SpecificationsPower Supply Specification LCD Touchmonitor 2400LM Dimensions Regulatory Information Electrical Safety InformationPage III. Agency Certifications Warranty Page Check out Elo’s Website