Blaupunkt RCM 169 operating instructions Quick Reference

Page 5

Quick Reference

1Unlocking the fold-down operating panel

After the operating panel has been un- locked it is possible to insert or remove

the KeyCard or a cassette.

Press 1 to unlock the panel, it will fold down forwards. The operating panel cannot be removed and must not be used as a storage shelf. To close and lock the operating panel, push it back to its original position (arrow 3).

2

1

3

For safety’s sake, the operating panel must always remain closed while the vehicle is mov- ing.

When you leave the vehicle, open the operating panel and re- move the KeyCard as added theft protection.

2ON

Switching the unit on:

With the KeyCard inserted, press ON briefly.

The unit will begin to operate in the mode last selected at the power-on volume.

When the unit is switched on for the first time, “INSTALL” will appear in the top line of the display. Now it is possi- ble to alter important basic settings, such as the clock, proof of ownership, reset to the default settings, etc.

If necessary, refer to the section on “First-time installation”.

Press EXIT to quit this menu.

Switching the unit off:

Press ON for approx. 1 sec.

The angle of the display can be adjust- ed to optimise its legibility. If neces- sary, refer to the section on “Optimis- ing the viewing angle”.

Switching the sound on/off:

Press ON briefly. If the sound has been switched off, “Mute” will appear in the display.

You can switch on the sound again by turning the volume knob 3.

Switching the unit on/off with the KeyCard:

The unit can also be switched on/off by inserting or removing the KeyCard. Also refer to No. B in the Quick Ref- erence for the section on the KeyCard theft protection system.

Switching the unit on/off with the ig- nition:

The unit can be switched on/off with the vehicle ignition if the unit has been installed accordingly.

After you switch off the ignition, you will hear a beep to remind you to re- move the KeyCard before you leave the vehicle.

Switching the unit on when the igni- tion is off

If the ignition is switched off (but the KeyCard in place), it is possible to op- erate the unit as follows:

DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS

53

Image 5

Contents Atlanta RCM Erklärung der Positions-Nummern siehe Kurzanleitung Contents Contents Quick Reference Next AM MW, LW Quick ReferenceNext FM PRE Menu level Adjusting the radio functionsFM, TS, TA, AM, PS, Scan ExitREG Regional PTYRT Radio text MonoMIX Radio station seek tuning Rocker switchCLR NameDIS AUD= CDC DisplayDOT field ? TU tuner KeyCard theft protection system Eject@ Cassette slot Visual theft protectionRC 08 remote control unit Important notes Operating the unit for the first time KeyCard theft protection systemRemoving the KeyCard Incorrect KeyCardKeyCard theft protection system Care of your KeyCard Training the new KeyCard Switching off the flashing lightLost or damaged KeyCard Activating the Install menu First-time installationClosing the Install menu Setting the clockSwitching the ignition connec- tion on/off First-time installationConnecting external equipment Reset to default settingsSelecting the operating Optimising the viewing Mode Angle AF Alternative frequency Switching between the menu levelsRadio operation with RDS Radio Data System Automatic tuning Station tuningRadio operation with RDS Radio Data System REG regional programStoring stations Scrolling through the broadcast- ing networks FM onlyChanging the memory bank FM To start Preset Scan Preset ScanScanning stored stations with Recalling stored stationsSwitching from stereo to mono Selecting the seek tuning sensi Automatic bandwidth adjustScanning stations with Radio Scan TivityProgram type Switching PTY on/offNews Selecting and storing PTY program typesRadio text PTY seek tuningTo select any program type Storing program typesSwitching the warning beep off Switching radio text offTraffic information station reception with RDS-EON Activating radio textSwitching on tape deck opera- tion Automatic seek tuning startTape operation Inserting a cassetteTape operation Selecting the display modeTrack reverse Scanning cassette titles withFast tape forward/rewind Repeating titles with RPTCare instructions Fast forward Fast rewindCD changer operation Switching on CD changer operationRepeating tracks/CDs CD changer operationSelecting tracks Deleting CD names/TPM at the same time Entering CD namesCD changer operation Clock Time Clock display when the audio system is switched offDisplaying the clock AutomaticallySynchronisation Selecting a 12 or 24-hour modeActivating the equalizer settings Self-adjusting equalizer Switching the equalizer on/offHi-fi self-adjustment Starting the hi-fi self-adjustmentManual equalizer adjustment Activating an equalizer settingAltering the setting manually JazzAdjusting DNC sensitivity Adjusting DNCSwitching DNC on/off Safety informationTUN Tuner DSC programmingVAR Various DSC programmingTOM ReadScan Scantime Sync CLK ClockSET CDC changer Overview of the DSC default settingsAmplifier Specifications Glossary Technical TerminologyTuner Tape deckREG Glossary Technical TerminologyGlossary Technical Terminology CPS IndexRDS-EON TPMBosch Gruppe Service-NummernUSA

Related manuals

Manual 44 pages 22.7 Kb