Blaupunkt RCM 104 A Adjusting the seek tuning sensi- tivity, REG Regional, Stereo mono switch FM

Page 11

Should the reception quality of the selected

Select the desired waveband by pres-

program become too bad,

 

sing the FMT or M•L button.

• tune into another program.

To switch between MW and LW:

 

press M•L.

Adjusting the seek tuning sensi- tivity

The set allows you to modify the seek tuning sensitivity.

REG - Regional

Certain radio programs are split up at times into regional programs offering local informa- tion. If you are listening to one program and move to an area where another linked regio- nal program becomes stronger, the unit will switch to that program. If you wish to continue listening to the first station:

Press the AF button for about 2 sec. The display will show “REG ON”.

If you leave the service area of the regional station tuned into, or if you would like to take advantage of the full RDS service, then switch to “REG OFF”.

Press the AF button for about 2 sec. until “REG OFF” is displayed.

Automatic seek tuning /

Press /. The radio will automatically tune into the following station.

If you keep the upper or lower part of the rocker switch / depressed, seek tuning speeds up in upwards or downwards direc- tion.

 

up

down in short

 

up in short

intervals

 

intervals

(when AF is off)

 

(when AF is off)

 

 

 

If “lo” is indicated, the radio will only pick up strong stations (low sensitivity).

If “lo” is deactivated, the radio will also pick up less powerful stations (higher sensitivity). The degree of sensitivity can be separately adjusted for both levels (see chapter “DSC programming“).

Stereo - mono switch (FM)

If reception is poor, you may get better sound quality if you switch to mono:

• Press lo for approximately 2 seconds.

The stereo symbol will disappear for mono

playback.

Each time the car radio is switched on, stereo

playback is activated.

The display will show “REG ON” or “REG

down

OFF” every time the radio is switched on.

 

The unit will automatically switch to mono

playback under poor reception conditions.

Selecting the waveband

This car radio can be used in any of the three following wavebands:

FM 87.5 - 108 MHz

MW 531 - 1602 kHz, and LW 153 - 279 kHz

Manual seek tuning << >>

Prerequisite: AF is switched off!

Press << or >> to change the frequency in small steps in upwards/ downwards direction.

If you hold down the right or left part of the rocker switch, then the car radio will move through the stations quickly.

34

Image 11
Contents Barcelona RCM 104 a 15 14 Table of contents FMT Switching onSwitching off Quick instructionsAUD DSC ModeAF Mode CPS? BC Dolby BC NR 3, 4, 5, 6 preset buttonsTIM/TA ScanMIX To change the seek tuning sensitivi- ty Press lo@ Eject button Press Cassette loading slot Tape side selectorWhat you really have to read Traffic safetyInstallation/connection Important notesReplacing a KeyCard KeyCardOptical indication of theft protection Never try to pull out the KeyCard by forceADA on/off antenna test RDS Radio Data SystemAF Alternative Frequency Selecting the waveband Adjusting the seek tuning sensi- tivityStereo mono switch FM REG RegionalRecalling stored stations Preset scanningChanging the memory bank FM Storing stationsProgram types Scanning stations with Radio ScanPTY Program Type PTY priority Tuning into a station with PTYTraffic announcement priority on/off Switching the warning beep offReception of traffic announcements with RDS-EON Enhanced Other NetworksTraffic Memo TIM Automatic seek tuning startAdjusting the traffic message volume Motor antenna could be damaged in a car wash Setting the time in the DSC menuAdjusting the TIM standby mode/TIM time Deactivating the TIM standby modeIf you are sure Do not switch on the radio until you have left the car washRT Radiotext Tape operation Winding with RM Radio Monitor Tions with BLS Blank SkipDolby BC NR Listening to the radio during fast Test DSC programmingTime ADAPlayback time NameCD name specified with CDC Name TimeTo quit the DSC mode and store the set- ting MIX MAG Switching the CD mode onUsing SRC of the car radio MIX CDDSC CD Disp Entering/displaying CD namesDeleting CD names VivaldiAppendix Survey of DSC default settingsTechnical data Blaupunkt-Werke GmbH